Radial stiffness characteristics of the overlap regions of sarcomeres in isolated skeletal myofibrils in pre-force generating state

Abstract

We have studied the stiffness of myofilament lattice in sarcomeres in the pre-force generating state, which was realized by a relaxing reagent, BDM (butane dione monoxime). First, the radial stiffness for the overlap regions of sarcomeres of isolated single myofibrils was estimated from the resulting decreases in diameter by osmotic pressure applied with the addition of Dextran. Then, the radial stiffness was also estimated from force-distance curve measurements with AFM technology. The radial stiffness for the overlap regions thus obtained was composed of a soft and a rigid component. The soft component visco-elastically changed in a characteristic fashion depending on the physiological conditions of myofibrils, suggesting that it comes from cross-bridge structures. BDM treatments significantly affected the soft radial component of contracting myofibrils depending on the approach velocity of cantilever: It was nearly equal to that in the contracting state at high approach velocity, whereas as low as that in the relaxing state at low approach velocity. However, comparable BDM treatments greatly suppressed the force production and the axial stiffness in contracting glycerinated muscle fibers and also the sliding velocity of actin filaments in the in vitro motility assay. Considering that BDM shifts the cross-bridge population from force generating to pre-force generating states in contracting muscle, the obtained results strongly suggest that cross-bridges in the pre-force generating state are visco-elastically attached to the thin filaments in such a binding manner that the axial stiffness is low but the radial stiffness significantly high similar to that in force generating state.

Nanoscopic changes in the lattice structure of striated muscle sarcomeres involved in the mechanism of spontaneous oscillatory contraction (SPOC)

“…59 ), and the mechanical properties of the Z-disks and the M-bands (e.g., Refs. 57,60 ). The amplitude of Aw oscillation (e.g., 4-6%; Fig.…”

A Review of Applications Using Mixed Materials of Cellulose, Nanocellulose and Carbon Nanotubes

“…These multifunctional filaments can be further manufactured as strain sensors that measure mass changes and investigate muscle movement and are expected to be used in the fields of portable gauge measurement and wearable bioelectronic therapy, as shown in Figure 6d [111]. Although young's modulus of skeletal muscle myofibrils under physiological conditions has been studied to be several MPa in the axial direction and several KPa in the radial direction [112,113], these applications are higher elastic properties than those. Other unique devices such as non-woven macrofiber mats using CNF and SWNTs have also been reported by Niu et al Features can be easily adjusted by controlling the extrusion pattern of the CNF-SWNT suspension in an ethanol coagulation bath and drying in air under limited conditions [114].…”