Pt/Au Nanoparticles@Co3O4 Cataluminescence Sensor for Rapid Analysis of Methyl Sec-Butyl Ether Impurity in Methyl Tert-Butyl Ether Gasoline Additive

Abstract

High purity methyl tert-butyl ether (MTBE) can be used to adjust gasoline octane values. However, an isomer, methyl sec-butyl ether (MSBE), is the main by-product of its industrial production, and this affects the purity of MTBE. Pt/Au NPs@Co3O4 composites with a hollow dodecahedron three-dimensional structure were synthesized using ZIF-67 as a template, with Pt and Au nanoparticles (NPs) evenly distributed on the shell of the hollow structure. A CTL sensor was established for the determination of MSBE based on the specificity of Pt/Au NPs@Co3O4. The experimental results showed that Pt/Au NPs@Co3O4 had a strong specific cataluminescence (CTL) response to MSBE, with no interference from MTBE. The linear range was 0.10–90 mg/L, the limit of detection was 0.031 mg/L (S/N = 3), the RSD was 2.5% (n = 9), and a complete sample test could be completed in five minutes. The sensor was used to detect MSBE in MTBE of different purity grades, with recoveries ranging from 92.0% to 109.2%, and the analytical results were consistent with those determined by gas chromatography. These results indicate that the established method was accurate and reliable, and could be used for rapid analysis of MTBE gasoline additive.

Non-Invasive Rapid Detection of Lung Cancer Biomarker Toluene with a Cataluminescence Sensor Based on the Two-Dimensional Nanocomposite Pt/Ti3C2Tx-CNT

“…Research shows that Pt has good oxidation resistance and high conductivity, and platinum can provide excitation electrons in CTL sensors. Therefore, adding it to a CTL sensor will further enhance the detection signal of the sensor and speed up its response and recovery time [19,[34][35][36]. Therefore, Pt was used as decoration to prepare Pt/Ti 3 C 2 T x -CNT catalyst in this paper.…”