Proposal for an Embedded System Architecture Using a GNDVI Algorithm to Support UAV-Based Agrochemical Spraying

Abstract

An important area in precision agriculture is related to the efficient use of chemicals applied onto fields. Efforts have been made to diminish their use, aiming at cost reduction and fewer chemical residues in the final agricultural products. The use of unmanned aerial vehicles (UAVs) presents itself as an attractive and cheap alternative for spraying pesticides and fertilizers compared to conventional mass spraying performed by ordinary manned aircraft. Besides being cheaper than manned aircraft, small UAVs are capable of performing fine-grained instead of the mass spraying. Observing this improved method, this paper reports the design of an embedded real-time UAV spraying control system supported by onboard image processing. The proposal uses a normalized difference vegetation index (NDVI) algorithm to detect the exact locations in which the chemicals are needed. Using this information, the automated spraying control system performs punctual applications while the UAV navigates over the crops. The system architecture is designed to run on low-cost hardware, which demands an efficient NDVI algorithm. The experiments were conducted using Raspberry Pi 3 as the embedded hardware. First, experiments in a laboratory were conducted in which the algorithm was proved to be correct and efficient. Then, field tests in real conditions were conducted for validation purposes. These validation tests were performed in an agronomic research station with the Raspberry hardware integrated into a UAV flying over a field of crops. The average CPU usage was about 20% while memory consumption was about 70 MB for high definition images, with 4% CPU usage and 20.3 MB RAM being observed for low-resolution images. The average current measured to execute the proposed algorithm was 0.11 A. The obtained results prove that the proposed solution is efficient in terms of processing and energy consumption when used in embedded hardware and provides measurements which are coherent with the commercial GreenSeeker equipment.

REDECA: A Novel Framework to Review Artificial Intelligence and Its Applications in Occupational Safety and Health

“…The same multispectral camera fixed on UAV technology was used to collect the data, and ML algorithms were used to discriminate between weed and vegetation with an overall accuracy of 96% [ 84 ]. The efficiency spraying of pesticides was shown to be improved by using ML algorithms to detect the exact locations reducing the need for workers’ exposure to pesticides [ 85 ].…”

Research on Methods Decreasing Pesticide Waste Based on Plant Protection Unmanned Aerial Vehicles: A Review

“…The response time of the system was largely reduced to 15.765 ms. Considering the demand for saving chemicals, a normalized difference vegetation index (NDVI) algorithm was created to detect the exact location where chemicals are needed ( Basso et al, 2019 ).…”

Olive Tree Biovolume from UAV Multi-Resolution Image Segmentation with Mask R-CNN

“…GNDVI index is more sensitive to variation in crop chlorophyll content than the NDVI index, and GNDVI also has a higher saturation threshold, so it can be used in crops with dense canopies or in more advanced development stages and to evaluate moisture content and nitrogen concentrations in plant leaves [ 14 ]. On the other hand, NDVI index is particularly suitable for estimating crop vigor during the initial development stages [ 13 , 15 ].…”