Properties of the wall structures made of autoclaved cellular concrete products on the polyurethane foam adhesive

Abstract

The article presents information on a test experiment for the construction of masonry fragments made of autoclaved cellular concrete products (ААС blocks) on the polyurethane adhesive and the ensuing structural, thermal and technological tests of this type of masonry in specialized laboratories and testing facilities. It is shown that the use of polyurethane foam adhesive to bond the concrete blocks in the masonry walls is technically and economically feasible. On the basis of the tests it was concluded that the laying of concrete blocks on the polyurethane adhesive may be used in the construction of non-load bearing interior and exterior walls of buildings, including the filling of the external frame openings of monolithic buildings with floor bearing of the masonry on load bearing monolithic floors (with appropriate justification of the settlement)

Setting the problem of designing monitoring systems for engineering structures and methods of its solution

“…Therefore, not only the impact must be controlled, but also the resistance to the impact. This simple truth was stated by leading Soviet scientists Rzhanitsin and Bolotin back in the sixties of the last century [30][31]. However, in scientific researches devoted to monitoring, only the effect is considered and practically no mention is made of resistance to this effect.…”

Formation of the strategy of management of innovation and investment activity of the enterprise

“…Based on the interrelationships of the above economic categories, the study proposes a classification of existing strategies for the development of the enterprise, depending on the degree of innovation use, which allowed to develop an algorithm for choosing the strategy of innovation and investment activity of the enterprise [5].…”

Advances in Raw Material Industries for Sustainable Development Goals

“…The quasi-stationary heat transfer mode can only be established in very short time intervals. The convenience of such a mode of heat transfer is stipulated by the fact that when considering it, all thermotechnical calculations that are used in design practice are greatly simplified (Gorshkov et al, 2013a;Gorshkov et al, 2013b;Zimin et al, 2013). Unsteady heat transfer also occurs when solving problems of heating and cooling objects, damping temperature fluctuations in structures and some others.…”