Properties and Corrosion Resistance Mechanism of a Self-Healing Propane–1,2,3-Triol-Loaded Polysulfone Microcapsule Coating Loaded with Epoxy Resin

Abstract

Propane–1,2,3-triol-loaded polysulfone (PSF) microcapsules were prepared by the solvent evaporation method. The particle size of the microcapsules is about 140 μm. The shell wall thickness is about 17 μm approximately. The microcapsules have high thermal stability and antiwear performance. The self-healing coating was prepared by adding the prepared capsule into the epoxy resin coating. After electrochemical and corrosion immersion experiments, the resistance modulus of the coating added to the microcapsules was higher than the others in a 3.5 wt % NaCl corrosion solution, and it had the lowest corrosion current density, so the self-healing microcapsule coatings showed excellent healing ability and corrosion inhibition function for microcracks. This was attributed to the formation of a hydrophobic film after propane–1,2,3-triol was released from the damaged microcapsules.

Sprayable Superhydrophobic Polydopamine-Modified Oleic Acid/Nanoscale SiO2Composites for Insulator Protective Coatings

“…The passage of electricity or high electric stress through cement increases the temperature of the cement and evaporates the moisture. The water vapor pressure then drives the voids in the concrete to penetrate the boundary. − …”

Superhydrophobic Surface on Insulators by Using Perfluoropolyether-Functionalized Silica Nanostructures for Preventing Stress Corrosion Cracking at the Pin–Cement Junction

“…Researchers usually mention friction stir welding as another potential repair method. However, such a method cannot be used for the onsite processing of insulators already in use. − As recently stated in articles 20 and 21, the shot peening, laser shock peening, and cold spray deposition techniques previously reported for stress corrosion cracking prevention would also create compressive stress on steel in the future. , …”

Fabrication of Hierarchical Patterned Surfaces Using a Functionalized CeO2-EPDM Composite for Crevice Corrosion Prevention on High-Voltage Insulators

“…Two different oxygen concentrations in two different locations result in a difference in electrical potential and, as a result, crevice corrosion. 5,6 Microorganism development has been evidenced in both ceramic and nonceramic insulators placed all over the world, particularly in tropical and subtropical conditions with high humidity, significant rainfall, and high temperature. It has been found that heterogeneous populations of bacteria, algae, moss, and fungus coexist in insulator biofilms.…”

“…The respiring microbial colonies within the crevice become anodic, causing the surrounding areas to become cathodic. Two different oxygen concentrations in two different locations result in a difference in electrical potential and, as a result, crevice corrosion. , …”

“…Two different oxygen concentrations in two different locations result in a difference in electrical potential and, as a result, crevice corrosion. 5 , 6 …”