Production of gasoline and diesel like fuels from waste tire oil by using catalytic pyrolysis

Ayanoğlu, Abdülkadir; Yumrutaş, Recep

doi:10.1016/j.energy.2016.02.155

Cited by 122 publications

(69 citation statements)

References 44 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The highest content of aromatic was found in ROS1 (36.94%) and the lowest was reflected in POS (29.48%). An obvious feature can be observed that these aromatics mainly include C8-C12 aromatics, Ayanoglu and Yumrutas [34] indicated that the aromatics of C8-C12 are the main components of gasoline. As for oxygenates, it can be seen from Table 3 that the higher oxygenates in the bio-oils of ROS1, SSOS, COS, SOS, ROS2, POS are alcohols and ketones.…”

Section: Effect Of Catalytic Temperature On Bio-oil Compositionmentioning

confidence: 99%

Microwave-assisted pyrolysis of vegetable oil soapstock: Comparative study of rapeseed, sunflower, corn, soybean, rice, and peanut oil soapstock

Wang

Zhang

et al. 2019

International Journal of Agricultural and Biological Engineering

View full text Add to dashboard Cite

In this study, the effects of catalytic temperature and the type of soapstock on products from microwave-assisted pyrolysis were investigated. HZSM-5 was used as the catalyst to study the pyrolysis of six different soapstocks at 200°C, 300°C, and 400°C catalytic temperature. Results showed that the bio-oil yields initially increased and then decreased with the increase in catalytic temperature. When the catalytic temperature was 300°C, the bio-oil reached up to the maximum value (65.8 wt.%). Findings indicated that the composition of bio-oil was related to the degree of unsaturation of fatty acids sodium in the soapstocks. In the case of saturated fatty acid sodium, a series of alkanes was formed, whereas the pyrolysis of monounsaturated fatty acid sodium resulted mainly in cycloalkanes, the cycloalkenes obtained from bio-oil was produced by polyunsaturated fatty acid sodium.

show abstract

Section: Effect Of Catalytic Temperature On Bio-oil Compositionmentioning

confidence: 99%

Microwave-assisted pyrolysis of vegetable oil soapstock: Comparative study of rapeseed, sunflower, corn, soybean, rice, and peanut oil soapstock

Wang

Zhang

et al. 2019

International Journal of Agricultural and Biological Engineering

View full text Add to dashboard Cite

show abstract

“…They reported that the lime mixture fuel sample at 10 wt % ratio shown the best results. They also reported that the characteristics of those light and heavy fuels were resembled to those of gasoline and diesel fuel [7]. Ma Xiaolong et al compared the vacuum pyrolysis with retorting and nitrogen sweeping pyrolysis, based on the yields and the properties of the pyrolysis products.…”

Section: Fig 1 Honge Treementioning

confidence: 99%

Studies on Improvement of Performance of Compression Ignition Engine Fuelled with Mixture of Honge Biodiesel and Tire Pyrolysis Oil

Kapilan

Jullya

2018

Strojnícky Časopis - Journal of Mechanical Engineering

View full text Add to dashboard Cite

The biodiesel has lower volatility and is costlier than the fossil diesel. Hence it is necessary to add a low cost fuel which has higher volatility, with the diesel. The tire pyrolysis oil (TPO) produced from waste tire and tubes have these desirable properties and hence in this work, we have mixed TPO with biodiesel to enhance the properties of the biodiesel. The engine tests were carried out on a single cylinder compression ignition engine with the mixture of biodiesel and TPO as fuel. From the engine tests, it is observed that the fuel mixture results in engine performance close to diesel operation at the higher injector nozzle opening pressure.

show abstract

“…quality of such fuel, including environmental characteristics, is required, which is costly. The possibility of separating liquid products of catalytic pyrolysis of tires into light and heavy fractions similar to gasoline and diesel fuel with their subsequent use instead of oil fuels is considered [44], without detailed discussion of the opportunities of wide-scale practical implementation.…”

Section: Introductionmentioning

confidence: 99%

An Investigation of the Feasibility of the Organic Municipal Solid Waste Processing by Coking

2019

View full text Add to dashboard Cite

In the context of transition to a circular economy, one of the strategic priorities is the development of technological innovations aimed at waste processing. In this study, the foundations have been developed for a low-temperature, environmentally safe method for efficient processing of organic municipal solid waste, which may be further applied for processing both municipal and industrial waste organics in order to obtain liquid products. The maximum yield of liquid products is ensured when conducting the coking of a mixture of organic waste with long residuum in the temperature range of 400-420 • C, with a heating rate of 5-70 • C/min, and with an optimal heating time to the coking temperature of 80 min. Recommendations on the use of the waste recycling products are given. The proposed process is consistent with the principles of circular economy and does not require external energy costs because the energy needed for the process is generated by burning the gas produced during the waste coking. The process does not produce emissions into the environment and, in combination with standard refining processes, can be used to obtain commercial petroleum products.Thermal methods of waste processing include incineration, torrefaction, pyrolysis, gasification [8,12]. The disadvantage of thermal waste processing methods is their high costs. These methods do not provide environmental safety of the process, and the products obtained are not suitable for use without additional quality improvement with the help of expensive processes. For instance, to increase the thermal efficiency of energy production from moisture-containing waste by pyrolysis and gasification, preliminary drying of raw materials is required, which increases operating costs. In thermal processing of waste, secondary slags are formed that require further utilization or disposal. The exhaust gases contain toxic compounds and require neutralization. Environmental impact caused by the processes of generating energy from waste was analyzed in review [13]. The points among all are local impacts from wood combustion and processes of the solid recovered fuel generation, also it should be noted that the innovative technologies applied to thermochemical processes at the waste-to-energy plants do not give absolute advantages in preventing environmental pollution.Processing of MSW is considered also as an opportunity to produce motor fuels, olefins and aromatic compounds [14,15]. In view of the fact that municipal solid waste can also contain non-combustible substances, there is a problem with the necessity of an expensive pre-treatment stage [16].There are a number of studies on thermal and catalytic decomposition of plastic waste [17][18][19][20][21][22]. The quality of plastic waste products derived through pyrolysis depends on the composition of the raw materials, and the effect of catalysts [19,23]. Joint catalytic processing of plastic waste and heavy oil residues is considered as a possible way to obtain fuel oil [24]. Cai et al. [25] offer alternative techn...

show abstract

Production of gasoline and diesel like fuels from waste tire oil by using catalytic pyrolysis

Cited by 122 publications

References 44 publications

Microwave-assisted pyrolysis of vegetable oil soapstock: Comparative study of rapeseed, sunflower, corn, soybean, rice, and peanut oil soapstock

Microwave-assisted pyrolysis of vegetable oil soapstock: Comparative study of rapeseed, sunflower, corn, soybean, rice, and peanut oil soapstock

Studies on Improvement of Performance of Compression Ignition Engine Fuelled with Mixture of Honge Biodiesel and Tire Pyrolysis Oil

An Investigation of the Feasibility of the Organic Municipal Solid Waste Processing by Coking

Contact Info

Product

Resources

About