Produção de estruvita a partir de esgoto doméstico.

Abstract

The shortage of the phosphorus sources and high-energy consumption associated to the nitrogen fertilizers production will be problems in the future. The nutrient recovery from wastewater as struvite has been considered as an alternative to alleviate these problems. In Latin America, production of struvite from wastewater is not yet a wellknown technology and therefore the purpose of this work is to contribute to a better understanding of the phenomena involved. This research work was performed in three phases: 1) production of struvite from upflow anaerobic sludge blanket reactor effluent; 2) production of struvite from anaerobic digester supernatant of enhanced biological phosphorus removal process (ADS-EBPR) and 3) influence of calcium in the struvite produced in the phase 2. In three phases, the magnesium concentrations were adjusted to obtain the preset phosphorus:magnesium (P:Mg) ratios and the pH was adjusted between 8,00 and 10,50. The results of the first phase showed that it is not possible to produce struvite in the upflow anaerobic sludge blanket reactor effluent in the tested conditions. However, removal of nitrogen and phosphorus was observed because amorphous calcium and magnesium phosphates were produced. The results of the second phase showed that it is possible to produce struvite in the ADS-EBPR and the molar consumptions of phosphate (PO4 3-), ammonia (NH4 +) and magnesium (Mg 2+) or removals (%) should not be the only parameters to evaluate the struvite formation, because other compounds crystallize or precipitate and reduce the quality of the mineral. In the similar conditions tested in this phase, a P:Mg ratio 1:2 and pH 9,50 assure maximum nutrients recovery as struvite with minimum impurities concentration, facilitating its subsequent use as fertilizer. The results of the third phase showed that amorphous calcium or magnesium phosphates were produced on the struvite surface.