Processing, mechanical, corrosion, and wear behavior of ZnO-reinforced Mg and Mg–Zr matrix composites for bioimplant applications

Azeem, M.A.; Kumar, A. Madhan; Abdelaal, Ahmed F.; Hussein, M.A.

doi:10.1016/j.matchemphys.2024.128884

Cited by 5 publications

(1 citation statement)

References 58 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Such cases fueled research for the development of biodegradable metallic implants. Mg alloys are increasingly being investigated as biodegradable metallic implants, along with Zn, Al, Fe, etc., based alloys and their composites. − However, the fast corrosion rate and structural instability are viewed as the current limitation for their clinical use …”

Section: Discussionmentioning

confidence: 99%

MgCa-Based Alloys Modified with Zn- and Ga-Doped CaP Coatings Lead to Controlled Degradation and Enhanced Bone Formation in a Sheep Cranium Defect Model

Gokyer,

Monsef,

Buyuksungur

et al. 2024

ACS Biomater. Sci. Eng.

View full text Add to dashboard Cite

Mg-based biodegradable metallic implants are gaining increased attraction for applications in orthopedics and dentistry. However, their current applications are hampered by their high rate of corrosion, degradation, and rapid release of ions and gas bubbles into the physiological medium. The aim of the present study is to investigate the osteogenic and angiogenic potential of coated Mg-based implants in a sheep cranial defect model. Although their osteogenic potential was studied to some extent, their potential to regenerate vascularized bone formation was not studied in detail. We have studied the potential of magnesium−calcium (MgCa)-based alloys modified with zinc (Zn)-or gallium (Ga)-doped calcium phosphate (CaP) coatings as a strategy to control their degradation rate while enhancing bone regeneration capacity. MgCa and its implants with CaP coatings (MgCa/CaP) as undoped or as doped with Zn or Ga (MgCa/CaP + Zn and MgCa/CaP + Ga, respectively) were implanted in bone defects created in the sheep cranium. MgCa implants degraded faster than the others at 4 weeks postop and the weight loss was ca. 50%, while it was ca. 15% for MgCa/CaP and <10% in the presence of Zn and Ga with CaP coating. Scanning electron microscopy (SEM) analysis of the implant surfaces also revealed that the MgCa implants had the largest degree of structural breakdown of all the groups. Radiological evaluation revealed that surface modification with CaP to the MgCa implants induced better bone regeneration within the defects as well as the enhancement of bone−implant surface integration. Bone volume (%) within the defect was ca. 25% in the case of MgCa/CaP + Ga, while it was around 15% for undoped MgCa group upon micro-CT evaluation. This >1.5-fold increase in bone regeneration for MgCa/CaP + Ga implant was also observed in the histopathological examination of the H&E-and Masson's trichrome-stained sections. Immunohistochemical analysis of the bone regeneration (antiosteopontin) and neovascularization (anti-CD31) at the defect sites revealed >2-fold increase in the expression of the markers in both Ga-and Zn-doped, CaP-coated implants. Zn-doped implants further presented low inflammatory reaction, notable bone regeneration, and neovascularization among all the implant groups. These findings indicated that Ga-and Zn-doped CaP coating is an important strategy to control the degradation rate as well as to achieve enhanced bone regeneration capacity of the implants made of Mg-based alloys.

show abstract