Processing, Characterization of Furcraea foetida (FF) Fiber and Investigation of Physical/Mechanical Properties of FF/Epoxy Composite

Abstract

In recent days the rising concern over environmental pollution with excessive use of synthetic materials has led to various eco-friendly innovations. Due to the organic nature, abundance and higher strength, natural fibers are gaining a lot of interest among researchers and are also extensively used by various industries to produce ecological products. Natural fibers are widely used in the composite industry as an alternative to synthetic fibers for numerous applications and new sources of fiber are continuously being explored. In this study, a fiber extracted from the Furcraea foetida (FF) plant is characterized for its feasibility as a reinforcement to fabricate polymer composite. The results show that the fiber has a density of 0.903 ± 0.07 g/cm3, tensile strength (σt) of 170.47 ± 24.71 MPa and the fiber is thermally stable up to 250 °C. The chemical functional groups and elements present in the FF fiber are evaluated by conducting Fourier transform infrared spectroscopy (FT-IR) and energy dispersive spectroscopy (EDS). The addition of FF fibers in epoxy reduced the density (13.44%) and hardness (10.9%) of the FF/Epoxy (FF/E) composite. However, the void content (Vc < 8%) and water absorption (WA: < 6%) rate increased in the composite. The FF/E composite with 30% volume of FF fibers showed maximum σt (32.14 ± 5.54 MPa) and flexural strength (σf: 80.23 ± 11.3 MPa).

Physicomechanical, water absorption and thermal properties and morphology of Paederia foetida fiber–Al2O3 powder hybrid‐reinforced epoxy composites

“…from 55.6 to 129.3 MPa) while the present SFD composite was much less sensitive to changes in material composition. Madival et al 58 developed an epoxy matrix composite reinforced by up to 30% Furcraea foetida (a similar plant to sisal) fibers: tensile strength reached again its maximum value for 30% volume fiber content but it was almost 35% lower than that of its counterpart SFD composite: only 32.1 versus 49.1 MPa. Sumesh and Kanthavel 28 analyzed hybrid sisal-banana fiber-reinforced epoxy composites: tensile strength was obtained for a 35% fiber content and is below that of the SFD composite (i.e.…”

Mechanical superiority of Pseudoxytenanthera bamboo for sustainable engineering solutions

“…The density of the Bamboo fibre was determined using a specific equation 25 . By employing these methods, researchers were able to accurately measure the diameter and density of bamboo fibres 26 , 28 . These parameters are essential for understanding the fibre's physical characteristics and its potential applications in various fields, including textiles, composites, and other engineering materials.…”

Preparation, Characteristics, and Application of Biopolymer Materials Reinforced with Lignocellulosic Fibres

“…Similarly, certain researchers made an effort to create a composite material by using a novel type of plant fibre that underwent surface modifications. Madival et al [52] conducted research on Furcraea foetida, a plant commonly found in the Caribbean and South America, to determine its potential as a source of fibre for composite materials. The researchers measured the density of the raw fibre and compared it with the density of chemically treated fibres.…”