Process Capability Improvement Using Internally Cooled Cutting Tool Insert in Cryogenic Machining of Super Duplex Stainless Steel 2507

Narayanan, Deeparekha; Jagadeesha, T.

doi:10.1007/978-981-15-2696-1_31

Cited by 6 publications

(1 citation statement)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…AISI 2205 [399,400], AISI 2507 [401][402][403][404] Hardness, wear, machinability, residual stress, and corrosion resistance Mostly in wind and solar energy Carbon steels IS 2062 [405], AISI 1045 [406][407][408][409][410][411][412], AISI 1018 [413] Hardness, wear, surface roughness, tensile strength, yield strength, ultimate tensile strength, elongation, and residual stress Steels can be used in hydroelectrical, biomass, solar, and geothermal energy Other steels Nitronic steels 40 [414], 50 [415] High-strength steels ASTM A36 [416] Cast steels ASTM A743 [417], SAE J431 G10 [418] ACSR [419] Bearing steel AISI 52100 [326,328,[420][421][422] Low-alloyed steels SAE 1008 [423], AISI 4340 [424], AISI 4140 [424] Structural steel S235 [425], S355 [426,427], S460 [428] Residual tress, hardness, friction, wear, fatigue, impact toughness, corrosion resistance, and machinability In all energy sectors Table 5 presents the non-ferrous alloys that have been CT-treated and have potential in the current and future energy sectors.…”

Section: Duplex Steelsmentioning

confidence: 99%

Sustainable New Technology for the Improvement of Metallic Materials for Future Energy Applications

Jovičević-Klug,

Rohwerder

2023

Coatings

View full text Add to dashboard Cite

The need for a more sustainable and accessible source of energy is increasing as human society advances. The use of different metallic materials and their challenges in current and future energy sectors are the primary focus of the first part of this review. Cryogenic treatment (CT), one of the possible solutions for an environmentally friendly, sustainable, and cost-effective technology for tailoring the properties of these materials, is the focus of second part of the review. CT was found to have great potential for the improvement of the properties of metallic materials and the extension of their service life. The focus of the review is on selected surface properties and corrosion resistance, which are under-researched and have great potential for future research and application of CT in the energy sector. Most research reports that CT improves corrosion resistance by up to 90%. This is based on the unique oxide formation that can provide corrosion protection and extend the life of metallic materials by up to three times. However, more research should be conducted on the surface resistance and corrosion resistance of metallic materials in future studies to provide standards for the application of CT in the energy sector.

show abstract