1969
DOI: 10.1103/physrev.186.942
|View full text |Cite
|
Sign up to set email alerts
|

Pressure-Induced Phonon Frequency Shifts Measured by Raman Scattering

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1
1

Citation Types

15
64
1
1

Year Published

1977
1977
2009
2009

Publication Types

Select...
5
3

Relationship

0
8

Authors

Journals

citations
Cited by 277 publications
(81 citation statements)
references
References 23 publications
15
64
1
1
Order By: Relevance
“…Further, as expected, compression of the sample produces variations in the Raman signal which are similar to those observed for sample cooling (Ref. 7).…”
Section: Description Of Solid-state Raman Scatteringsupporting
confidence: 82%
“…Further, as expected, compression of the sample produces variations in the Raman signal which are similar to those observed for sample cooling (Ref. 7).…”
Section: Description Of Solid-state Raman Scatteringsupporting
confidence: 82%
“…The E 1 (LO) mode positioned at about 580 cm -1 attributable to the formation of zinc interstitials and oxygen vacancies is not found in this figure, suggesting relatively low defect density in these films [18,19]. For ZnO, the E 2 (high) mode frequency shifts relative to the single crystal value can be used to estimate residual stress in thin films [20,21]. The E 2 frequency of the (0 0 0 1) ZnO film on LGO (0 0 1) is 436 cm -1 , which has a red shift as compared with that of bulk ZnO, indicating the c-plane film is under a residual tensile stress.…”
Section: Resultsmentioning
confidence: 99%
“…This is very crucial in growing high-quality LiGaO 2 crystal. The optimum growth conditions were found to be a pulling rate of 2-3 mm/h and rotation rate of [20][21][22][23][24][25][26][27][28][29][30] rpm. Finally, a colorless and transparent LiGaO 2 crystal was obtained.…”
Section: Methodsmentioning
confidence: 99%
“…2). Using the pressure coefficient (5.2 Â 10 À9 cm À1 Pa À1 ) determined by Mitra et al [9], we calculated that the as-prepared thin films are under slight compressive stress, about 1.5 Â 10 8 Pa for S 1 and 2.0 Â 10 8 Pa for S 2 , which are less than those of ZnO epilayers deposited on other substrates [10]. Fig.…”
Section: Resultsmentioning
confidence: 93%