Preparation of MSE-type Titanosilicate via Crystallization of Titanoaluminosilicate and Its Catalytic Use for Selective Oxidation of Phenol Using H<sub>2</sub>O<sub>2</sub>

Ikehara, Yuya; Ohno, Yuya; Inagaki, Shigenori; Kubota, Yoshihiro

doi:10.1246/cl.170832

Cited by 9 publications

(2 citation statements)

References 37 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The MCM-68 modified with Zn showed a relatively high selectivity in the reaction of methanol to aromatics . In addition, a titanosilicate version of MCM-68 ([Ti]-MCM-68) − or YNU-2 ([Ti]-YNU-2) have exhibited a high catalytic performance compared with that of TS-1 for the oxidation (hydroxylation) of phenols with H 2 O 2 as an oxidant.…”

Section: Introductionmentioning

confidence: 99%

Crystallization Behavior of Highly Defective MSE-Type Zeolite, Incorporation of Ti into the Framework, and Its Hydrophobic–Hydrophilic Nature Controlled by Post-Synthesis Modifications

Inagaki

Kaneda

Haikal

et al. 2023

Crystal Growth & Design

Self Cite

View full text Add to dashboard Cite

YNU-2 is a pure-silica version of MSE-type zeolite obtained by steam-assisted crystallization (SAC) technique, followed via suitable stabilization by postsynthesis modification. Taking advantage of the SAC method, the change of zeolitic phase during the crystallization was tracked. In the presence of organic structure-directing agent (OSDA), the Beta phase first appeared as an intermediate followed by the formation of OSDA-MSE composite, YNU-2P, as the final crystallization product. When the YNU-2P was directly calcined at temperatures higher than 400 °C to remove the occluded OSDA, the MSE framework collapsed due to the existence of a large number of site defects in the framework. The highly crystalline YNU-2 was only obtained when the YNU-2P was steamed or acid-treated under appropriate conditions. The framework stabilization was achieved by various techniques that cause Si-migration. The extent of Si-migration was dependent on the treatment conditions. For the Ti-incorporation to prepare [Ti]-YNU-2, enough but incomplete Si-migration by steaming is necessary rather than thorough acid-treatment to fill all the site defects. [Ti]-YNU-2 exhibits a catalytic performance superior to that of [Ti]-MCM-68, even though the former has a local hydrophilic field in the micropores that gives a type-V water adsorption isotherm, suggesting that the Si-migration occurs during the steaming and generates hydrophilic supermicropores.

show abstract

Section: Introductionmentioning

confidence: 99%

Crystallization Behavior of Highly Defective MSE-Type Zeolite, Incorporation of Ti into the Framework, and Its Hydrophobic–Hydrophilic Nature Controlled by Post-Synthesis Modifications

Inagaki

Kaneda

Haikal

et al. 2023

Crystal Growth & Design

Self Cite

View full text Add to dashboard Cite

show abstract

“…The direct hydrothermal synthesis of Ti-MSE is difficult, because the large amounts of Na + and K + ions, necessary for constructing of the MSE structure as mineralizing agents in synthetic gel, retarded the introduction of Ti into the framework. 19 As a result, the complexity and cost of Ti-MSE synthesis are mainly determined by the synthetic procedures of its aluminosilicate or silicate precursor and the organic structure-directing agent (OSDA) used in the synthesis. The preparation of an MSE-type aluminosilicate, MCM-68, needs the OSDA N , N , N ′, N ′-tetraethylbicyclo[2.2.2]oct-7-ene-2,3:5,6-dipyrrolidinium diiodide (TEBOP 2+ (I − ) 2 ), which is commercially unavailable and requires complicated synthesis procedures.…”

Section: Introductionmentioning

confidence: 99%

Post-synthesis of MSE-type titanosilicates by interzeolite transformation for selective anisole hydroxylation

Peng

Pan

et al. 2022

Catal. Sci. Technol.

View full text Add to dashboard Cite

show abstract

Synthesis of Titanosilicates

2024

Micro‐Mesoporous Metallosilicates

View full text Add to dashboard Cite

Preparation of MSE-type Titanosilicate via Crystallization of Titanoaluminosilicate and Its Catalytic Use for Selective Oxidation of Phenol Using H₂O₂

Cited by 9 publications

References 37 publications

Crystallization Behavior of Highly Defective MSE-Type Zeolite, Incorporation of Ti into the Framework, and Its Hydrophobic–Hydrophilic Nature Controlled by Post-Synthesis Modifications

Crystallization Behavior of Highly Defective MSE-Type Zeolite, Incorporation of Ti into the Framework, and Its Hydrophobic–Hydrophilic Nature Controlled by Post-Synthesis Modifications

Post-synthesis of MSE-type titanosilicates by interzeolite transformation for selective anisole hydroxylation

Synthesis of Titanosilicates

Contact Info

Product

Resources

About

Preparation of MSE-type Titanosilicate via Crystallization of Titanoaluminosilicate and Its Catalytic Use for Selective Oxidation of Phenol Using H2O2

Cited by 9 publications

References 37 publications

Crystallization Behavior of Highly Defective MSE-Type Zeolite, Incorporation of Ti into the Framework, and Its Hydrophobic–Hydrophilic Nature Controlled by Post-Synthesis Modifications

Crystallization Behavior of Highly Defective MSE-Type Zeolite, Incorporation of Ti into the Framework, and Its Hydrophobic–Hydrophilic Nature Controlled by Post-Synthesis Modifications

Post-synthesis of MSE-type titanosilicates by interzeolite transformation for selective anisole hydroxylation

Synthesis of Titanosilicates

Contact Info

Product

Resources

About

Preparation of MSE-type Titanosilicate via Crystallization of Titanoaluminosilicate and Its Catalytic Use for Selective Oxidation of Phenol Using H₂O₂