Preparation and performance of Ti/Ti-DLC composite coatings for precision glass molding

Shu, Chengsong; Yin, Shaohui; Huang, Shuai

doi:10.1016/j.ceramint.2023.11.267

Cited by 4 publications

(1 citation statement)

References 41 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Das et al (2020) deposited TiCN coatings using thermal CVD at high temperature by varying the N2 flow rate and observed that N2 flowrate has a significant effect over the tribomechanical properties of TICN coatings at high temperature. Shu et al (2024) contributed to this field by enhancing the performance of Ni-P molds used in precision glass molding. By depositing Ti/Ti-DLC layers using Filtered Cathodic Vacuum Arc (FCVA), they significantly improved the wear resistance and stability of these molds.…”

Section: Introductionmentioning

confidence: 99%

Effect of deposition temperature on the tribo-mechanical properties of nitrogen doped DLC thin film

Shanmugasundar,

Vanitha,

Logesh

et al. 2024

Front. Mech. Eng.

View full text Add to dashboard Cite

The tribomechanical characteristics of diamond-like carbon (DLC) coatings are notably superior to other hard coatings, making them highly desirable for industrial applications. This study focuses on the synthesis of nitrogen-doped DLC (N-DLC) films through chemical vapor deposition (CVD) methods, with an emphasis on varying the deposition temperature. Comprehensive characterization techniques such as atomic force microscopy (AFM), scanning electron microscopy (SEM), and nanoindentation were employed to investigate the morphological and mechanical attributes of these coatings. The thickness of the films, measured using a Dektak profilometer, demonstrated an increase from 1.9 to 2.8 µm as the deposition temperature rose. Nanoindentation testing revealed that the film deposited at 900°C exhibited the highest hardness (H) and modulus of elasticity (E), measuring 21.95 and 208.3 GPa, respectively. Conversely, the film deposited at 1,000°C showed the lowest values, with H and E at 14.23a and 141.9 GPa, respectively. The H/E ratio of the coatings initially rose from 0.096 to 0.106 as the deposition temperature increased from 800°C to 900°C. However, for deposition temperatures exceeding 900°C the H/E ratio began to decline.

show abstract

Section: Introductionmentioning

confidence: 99%