Preliminary Characterization and Projections of PVD Coatings On SiC Cladding for Light Water Reactors

Ang, Caen; Carpenter, David; Terrani, Kurt A.; Katoh, Yutai

doi:10.1002/9781119543381.ch12

Cited by 1 publication

(1 citation statement)

References 44 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…However, this test is sparsely reported for the characterization of PVD coatings, as the maximum adhesion strength that can be measured is limited by the bond strength between the fixture and the adhesive [31]. In fact, investigations conducted by Ang et al on the assessment of the bond strength of TiN and CrN coatings deposited on SiC using epoxy adhesives revealed inconclusive results due to the adhesive failure at the fixture-adhesive interface [145]. Therefore, the pull-off test might not be suitable for characterizing the adhesion strength of CAE-PVD coatings.…”

Section: Coating Adhesionmentioning

confidence: 99%

A Comprehensive Review of Cathodic Arc Evaporation Physical Vapour Deposition (CAE-PVD) Coatings for Enhanced Tribological Performance

Muhammed,

Javidani,

Ebrahimi Sadrabadi

et al. 2024

Coatings

View full text Add to dashboard Cite

In the realm of industries focused on tribology, such as the machining industry, among others, the primary objective has been tribological performance enhancement, given its substantial impact on production cost. Amid the variety of tribological enhancement techniques, cathodic arc evaporation physical vapour deposition (CAE-PVD) coatings have emerged as a promising solution offering both tribological performance enhancement and cost-effectiveness. This review article aims to systematically present the subject of CAE-PVD coatings in light of the tribological performance enhancement. It commences with a comprehensive discussion on substrate preparation, emphasizing the significant effect of substrate roughness on the coating properties and the ensuing tribological performance. The literature analysis conducted revealed that optimum tribological performance could be achieved with an average roughness (Ra) of 0.1 µm. Subsequently, the article explores the CAE-PVD process and the coating’s microstructural evolution with emphasis on advances in macroparticles (MPs) formation and reduction. Further discussions are provided on the characterization of the coatings’ microstructural, mechanical, electrochemical and tribological properties. Most importantly, crucial analytical discussions highlighting the impact of deposition parameters namely: arc current, temperature and substrate bias on the coating properties are also provided. The examination of the analyzed literature revealed that the optimum tribological performance can be attained with a 70 to 100 A arc current, a substrate bias ranging from −100 to −200 V and a deposition temperature exceeding 300 °C. The article further explores advancements in coating doping, monolayer and multilayer coating architectures of CAE-PVD coatings. Finally, invaluable recommendations for future exploration by prospective researchers to further enrich the field of study are also provided.

show abstract

Section: Coating Adhesionmentioning

confidence: 99%