Precursor effect on the Fe-doped cryptomelane (Fe-OMS-2) prepared via one-step sol-gel route as heterogeneous Fenton catalyst for degradation of methylene blue

Abstract

The pristine cryptomelane (OMS-2) and Fe-OMS-2 (1%, 5%, and 10%) have been successfully synthesized by a one-step sol-gel method and characterized by XRD, SEM, BET surface area and AAS. The incorporation of Fe (III) within the structure of OMS-2 leads to an increase in surface area, pore-volume, and catalytic activity for the degradation of methylene blue (MB) and a decrease in the content of K+ and average of pore diameter. The catalytic test indicated that the catalytic activity of Fe-OMS-2 1% is considerably higher that of pure OMS-2. The highest degradation of MB is 93.5% achieved using Fe-OMS-2 1% after 120 minutes of degradation time, the initial concentration of MB of 20 ppm, the catalyst concentration of 0.125 mg and the H2O2 volume of 15 mL. The enhanced catalytic activities of Fe-OMS-2 compared to pristine OMS-2 for catalytic degradation of MB are associated with an increase in surface area, pore-volume, and smaller particle size. The results from catalytic studies imply that the metal doping is an effective strategy to enhance the catalytic activities of OMS-2 for degradation of MB.

The Catalytic Activity Of Manganosite MnO/Activated Carbon For Photo-Degradation Of Synthetic Dye

“…The tunnel or layer structures occur depending upon the arrangement of MnO6 octahedral units, which result in the formation of 1x1, 2x1, 2x2, and 3x3 tunnels [2,3]. Many manganese oxides have been succesfully synthesized by various synthetic method, such as sol-gel [4][5][6][7], solid-state [3], precipitation [8][9][10][11], reflux [12] and hydrothermal [13]. Manganese oxides exist in nature as mixed valences Mn (Mn 2+ /Mn 3+ /Mn 4+ ) that could facilitate redox reaction.…”

Validation of Methylene Blue Analysis Method in Wastewater Samples by Uv-Vis Spectrophotometry

“…One of the most widely used analytical methods is UV-Vis spectrophotometry, which utilizes ultraviolet and visible light to measure the absorbance of a chemical compound in a sample. Where the absorbance value of the light that is passed will be proportional to the concentration of the solution in the cuvette [7]. However, before this method can be used, it is necessary to validate the analytical method first.…”