Precipitation behaviors and property variations of Cu-3.0 wt% Ti fabricated by a novel short-processing non-vacuum heating-cooling combined mold continuous casting

Fu, Yilei; Xie, Guoliang; Zhao, Fan; Wan, Jinfeng; Meng, Xianghao; Liu, Xiao; Wang, Rui; Liu, Xinhua

doi:10.1016/j.jallcom.2022.166059

Cited by 12 publications

(1 citation statement)

References 36 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…However, alloy ingots are prerequisites for internal oxidation to take place. The heating–cooling combined mold (HCCM) continuous casting represents an innovative processing method for acquiring superior ingots characterized by exceptional deformability and surface quality [ 18 ]. This is attributed to the substantial temperature gradient observed at the leading edge of solid–liquid interfaces in the casting direction.…”

Section: Introductionmentioning

confidence: 99%

Influence of Heat Treatment Condition on the Microstructure, Microhardness and Corrosion Resistance of Ag-Sn-In-Ni-Te Alloy Wire

Shao,

Zhang,

et al. 2024

Materials

View full text Add to dashboard Cite

Ag-Sn-In-Ni-Te alloy ingots were produced through a heating–cooling combined mold continuous casting technique; they were then drawn into wires. However, during the drawing process, the alloy wires tended to harden, making further diameter reduction challenging. To overcome this, heat treatment was necessary to soften the previously drawn wires. The study investigated how variations in heat treatment temperature and holding time affected the microstructure, microhardness and corrosion resistance of the alloy wires. The results indicate that the alloy wires subjected to heat treatment at 700 °C for 2 h not only exhibited a uniform microstructure distribution, but also demonstrated low microhardness and excellent corrosion resistance.

show abstract

Section: Introductionmentioning

confidence: 99%