Pre-analytical variables influence zinc measurement in blood samples

Abstract

Zinc deficiency continues to be a major concern for global public health. The zinc status of a target population is typically estimated by measuring circulating zinc levels, but the sampling procedures are not standardized and thus may result in analytical discrepancies. To examine this, we designed a study that controlled most of the technical parameters in order to focus on five pre-analytical variables reported to influence the measurement of zinc in blood samples, including (1) blood draw site (capillary or venous), (2) blood sample matrix (plasma or serum), (3) blood collection tube manufacturer (Becton, Dickinson and Company or Sarstedt AG & Co), (4) blood processing time (0, 4, or 24 hours), and (5) blood holding temperatures (4°C, 20°C, or 37°C). A diverse cohort of 60 healthy adults were recruited to provide sequential capillary and venous blood samples, which were carefully processed under a single chain of custody and measured for zinc content using inductively coupled plasma optical emission spectrometry. When comparing blood draw sites, the mean zinc content of capillary samples was 0.054 mg/L (8%; p<0.0001) higher than venous blood from the same donors. When comparing blood sample matrices, the mean zinc content of serum samples was 0.029 mg/L (5%; p<0.0001) higher than plasma samples from the same donors. When comparing blood collection tube manufacturer, the mean zinc content from venous blood samples did not differ between venders, but the mean zinc content from BD capillary plasma was 0.036 mg/L (6%; p<0.0001) higher than Sarstedt capillary plasma from the same donors. When comparing processing times, the mean zinc content of plasma and serum samples was 5–12% higher (p<0.0001) in samples processed 4–24 hour after collection. When comparing holding temperatures, the mean zinc content of plasma and serum samples was 0.5–7% higher (p = 0.0007 or p = 0.0061, respectively) in samples temporarily held at 20°C or 37°C after collection. Thus even with the same donors and blood draws, significant differences in zinc content were observed with different draw sites, tube types, and processing procedures, demonstrating that key pre-analytic variables can have an impact on zinc measurement, and subsequent classification of zinc status. Minimizing these pre-analytical variables is important for generating best practice guidelines for assessment of zinc status.

Effect of multiple micronutrient-fortified bouillon on micronutrient status among women and children in the Northern Region of Ghana: Protocol for the Condiment Micronutrient Innovation Trial (CoMIT), a community-based randomized controlled trial

“…Plasma [ 51 ] and breast milk [ 52 ] vitamin A concentrations will be measured by high performance liquid chromatography (HPLC) at the UCD (Davis, CA). Plasma zinc concentrations will be analyzed by inductively-coupled plasma optical emission spectrophotometry (ICP-OES; Agilent 5100 SVDV, Santa Clara, CA) at the University of California, San Francisco (UCSF) Benioff Children’s Hospital (Oakland, CA) [ 53 ]. Whole blood folate and serum/plasma folate will be analyzed by the US Centers for Disease Control and Prevention (Atlanta, GA) and used to calculate erythrocyte folate concentrations [ 54 ].…”

Potential Complementary Effect of Zinc and Alkalihalobacillus clausii on Gut Health and Immunity: A Narrative Review

“…The evaluation of zinc status in a particular population is commonly determined by examining circulating zinc levels [ 78 ]. However, as a result of a lack of standardisation in sampling procedures, there have been inconsistencies in the results obtained, and different methods have been developed to assess the prevalence of inadequate global zinc intake [ 30 ].…”

Serum Zinc Levels in Women with Polycystic Ovarian Syndrome Are Lower as Compared to Those without Polycystic Ovarian Syndrome: A Cohort Study

“…Significant variations in SZ content were found with various tube types, aspiration sites and processing procedures, pointing that these variables could importantly affect SZ estimation and subsequent categorisation of zinc profile. [ 4 ] Decreasing these variables is a critical prerequisite for accurate SZ level measurement.…”