Power system stabilizer design using μ synthesis

Chen, S.; Malik, O.P.

doi:10.1109/60.372584

Cited by 75 publications

(36 citation statements)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Some of those efforts have been contributed to design robust controllers for PSS and/or FACTS devices using H ∞ concept such as mixed-sensitivity [7][8][9][10]; µ -synthesis or structured singular value (SSV) [11] and H 2 norm concept such as LQG [12].…”

Section: Introductionmentioning

confidence: 99%

Multiobjective H2/H∞ Control Design with Regional Pole Constraints

Hardiansyah

Junaidi

2012

TELKOMNIKA

View full text Add to dashboard Cite

This paper presents multiobjective H2/H∞ control design with regional pole constraints. The state feedback gain can be obtained by solving a linear matrix inequality (LMI) feasibility problem that robustly assigns the closed-loop poles in a prescribed LMI region. The proposed technique is illustrated with applications to the design of stabilizer for a typical single-machine infinite-bus (SMIB) power system. TheLMI-based control ensures adequate damping for widely varying system operating conditions. The simulation results illustrate the effectiveness and robustness of the proposed stabilizer.

show abstract

Section: Introductionmentioning

confidence: 99%

Multiobjective H2/H∞ Control Design with Regional Pole Constraints

Hardiansyah

Junaidi

2012

TELKOMNIKA

View full text Add to dashboard Cite

show abstract

“…The basic purpose is to mechanize the synthesis of multivariable feedback controllers that are insensitive to uncertainties of the plant and be able to attain the anticipated performance objectives. This method is well described in [120,121].…”

Section: μ-Synthesis Controllersmentioning

confidence: 99%

Digital Control Techniques Based on Voltage Source Inverters in Renewable Energy Applications: A Review

et al. 2018

View full text Add to dashboard Cite

Abstract:In the modern era, distributed generation is considered as an alternative source for power generation. Especially, need of the time is to provide the three-phase loads with smooth sinusoidal voltages having fixed frequency and amplitude. A common solution is the integration of power electronics converters in the systems for connecting distributed generation systems to the stand-alone loads. Thus, the presence of suitable control techniques, in the power electronic converters, for robust stability, abrupt response, optimal tracking ability and error eradication are inevitable. A comprehensive review based on design, analysis, validation of the most suitable digital control techniques and the options available for the researchers for improving the power quality is presented in this paper with their pros and cons. Comparisons based on the cost, schemes, performance, modulation techniques and coordinates system are also presented. Finally, the paper describes the performance evaluation of the control schemes on a voltage source inverter (VSI) and proposes the different aspects to be considered for selecting a power electronics inverter topology, reference frames, filters, as well as control strategy.

show abstract

“…Recently, many researchers have investigated the use of optimization [5]- [7] and -synthesis [8], [9] for power system robust damping control design. The concept of loop-shaping design was proposed by McFarlane and Glover [10]- [12].…”

mentioning

confidence: 99%

“…From technical as well as commercial considerations, it is thus desirable to have a dynamic system emulator that can physically emulate the dynamic behavior of the power system in real time. Studies reported in [3], [4], [8], and [9] described simulation results. The implementation and experimental verification of a robust FACTS controller is described in this paper.…”

mentioning

confidence: 99%

Design and Real-Time Implementation of Robust FACTS Controller for Damping Inter-Area Oscillation

Majumder

Pal

Dufour

et al. 2006

IEEE Trans. Power Syst.

View full text Add to dashboard Cite

Abstract-An application of a normalized loop-shaping technique for design and simplification of damping controllers in the liner matrix inequalities (LMI) framework is illustrated in this paper. The solution is sought numerically using LMIs with additional pole-placement constraints. This ensures that the time-domain specifications are met besides robust stabilization. The designed control algorithm is implemented using a rapid prototyping controller. The performance of the controller is validated in real time using a detailed model of the power system implemented using Linux PC-based, multi-processor technology. The coupling between the controller and the power system is through a set of DAC and ADC modules in the analogue domain.

show abstract

Power system stabilizer design using μ synthesis

Cited by 75 publications

References 8 publications

Multiobjective H2/H∞ Control Design with Regional Pole Constraints

Multiobjective H2/H∞ Control Design with Regional Pole Constraints

Digital Control Techniques Based on Voltage Source Inverters in Renewable Energy Applications: A Review

Design and Real-Time Implementation of Robust FACTS Controller for Damping Inter-Area Oscillation

Contact Info

Product

Resources

About