Potential Power of the Pyramidal Structure

Abstract

There have been various traditions and books which describe a so-called "pyramid power", but there have been almost no reliable academic studies and no statistically significant data about it. We have continued scientifically rigorous experiments using biosensors to elucidate unexplained functions of a pyramidal structure (PS) since 2007. We used edible cucumber sections as biosensors and measured the concentrations of gas emitted from the sections by a technique developed by our group. From them we have demonstrated with high statistical accuracy the existence of the "pyramid power", which was often recognized as having no scientific basis. We reached two conclusions from the work. 1) The PS converted the unconsciousness of a human (the test subject) more than 6 km away to energy detectable by the biosensors (1% significance). 2) The PS accumulated the influence that a human (the test subject) had when meditating within the PS. Then the PS converted the influence into the energy detectable by the biosensors (10 −3 % significance). These two conclusions showed that the functions of the PS were detected when "the PS and a human were related". On the other hand, we hypothesized that the potential power of the PS could be detected even when "the PS and a human were not related". In this paper, our purpose is to verify the existence of the potential power of the PS alone by experiment when "the PS and a human were not related". The following three results were obtained by experiment. 1) The presence of the potential power of the PS was demonstrated with 1% significance. 2) The potential power of the PS changed in value between summer and winter, and it was clear that the non-contact effect on the biosensors was larger in summer and smaller in winter. 3) The potential power of the PS affected only the biosensors placed at the PS apex, and did not affect the biosensors placed at the calibration control point 8 m away from the PS. This paper is the first report in the world to show this type of effect by scientific measurements. Our research results may open up a new science field of "pyramid power", from which we Open Access

Potential Power of the Pyramidal Structure III: Discovery of Pyramid Effects with and without Seasonal Variation

“…(ii) Pyramid effects in which the potential power of the PS affected the biosensors if the test subject had not been inside the PS for at least 20 days and the test subject's unexplained energy was excluded. We reported two results on (ii) in previously published papers [27,28]. 1) We demonstrated the pyramid effect that affects the biosensors placed at the PS apex by the potential power of the PS.…”

“…We expressed the pyramid effects on the biosensors by the psi index Ψ [27,28,32]. Ψ was 100 times the natural logarithm of the ratio calculated for the gas concentrations of each pair.…”

“…Figure 3(a) shows the distribution of Ψ (E-CAL)LayerAve . The total number of data was n = 468, which were results of experiments conducted between July 2010 and September 2017 [27,28]. The horizontal axis is the number of days (1 -366) counted from January 1st of each year.…”

“…As a result of rigorous scientific experiments and analysis, the existence of an unexplained "power" of the PS, an unexplained "function" of the PS was demonstrated with statistically very high significance. The results of our research on the PS have been published as eight original papers [21][22][23][24][25][26][27][28], three research summaries [29][30][31], and one chapter in a book [32].…”

“…1) We demonstrated the pyramid effect that affects the biosensors placed at the PS apex by the potential power of the PS. When the year was divided into two periods, the spring equinox and the autumn equinox, a significant difference was obtained as a result of comparing the pyramid effects of each period, p = 6.0 × 10 −3 , Welch's t-test, two-tails [27] (the following p values are also the Welch's t-test values). 2) We demonstrated that the potential power of the PS affected the biosensors placed in two layers with a difference of 20 mm in height at the PS apex, and the pyramid effect differed between the lower and the upper layer.…”