Position-servo drives with finite control

IOP Conf. Ser.: Mater. Sci. Eng.

2017

Abstract. Different ways to improve the energy efficiency of electric drives of cold pilgering mill are considered. Mathematical modeling methods represent studies according to which it is possible to evaluate quantitatively the energy savings. For example, cold pilgering mill 450 shows the mean square of the armature current of the main drive motor related to critical frequency of the speed loop. The possibility of energy saving by previous field weakening of the motor before the operating cycle of rolling is considered. The optimal energy saving points of supply and termination of the pulse are determined by the field weakening. The correlation of the parameters of the dynamic units and the change of the electric drive work schedule provides the greatest loss reduction in the main drive of the cold pilgering mill stand based on the conditions. Activities aimed at improving energy efficiency of electric drives of mills of this group are reviewed, which reduces the electric energy consumption for the cycle rolling by 20-25 %.

Section: Introductionmentioning

confidence: 99%

Energy efficiency improvement of electric drive of cold pilgering mill

Sychev

Savosteenko

IOP Conf. Ser.: Mater. Sci. Eng.

2017

Synthesis of energy-efficient agriculture electric drives control system

Bukhanov

IOP Conf. Ser.: Earth Environ. Sci.

Григорьев

2019

In this paper the capabilities of the agriculture electric drive with rectangular shape of the phase current were analyzed, the level of pulsations of the electromagnetic torque in synchronous reluctance electric drives was found, the synthesis of the electric drive control system was considered, the characteristics of the electric drive under different control laws were compared. It is found that the use of high-speed current circuits (cutoff frequency = > 200 rad/s) can significantly suppress the level of pulsations of the electromagnetic torque. It is shown that the use of flexible positive current feedback in switching phase currents can be considered as an additional opportunity to improve the performance of the current control circuit, as well as in conjunction with the previous method for suppressing torque pulsations in both static and dynamic modes.

Design of electric drives with the improved mass-dimensional indicators for agricultural facilities

IOP Conf. Ser.: Earth Environ. Sci.

Bukhanov

Григорьев

2019

The article systematizes information on the structure of regulation of non-contact agricultural electric drives with improved mass-size parameters. Regulatory structures with independent control two-zone speed control and sequential excitation are proposed. It is shown that the best indicators are achieved in the scheme of sequential excitation and they reach values of 20-25%. Attention is drawn to the fact that structures with independent excitation are most relevant for dynamic mechanisms that realize the trajectory of motion with the maximum speed. Schemes of sequential excitation are most relevant for mechanisms with a large range of load variations on the motor shaft, for example, agricultural facilities. Schemes with two-zone speed control are most relevant for mechanisms that, with a large increase in speed, significantly reduce the load on the motor shaft.