Pitched unventilated wood frame roof with smart vapour barrier – field measurements

Abstract

Unventilated wood-frame roofs may provide smaller roof thickness and less material use compared to conventional unventilated roofs with all the thermal insulation above the load bearing structure. Unventilated roofs are, however, normally built without wooden materials between the vapour barrier and roof membrane due to moisture safety. Field measurements on the pitched unventilated wood-frame roof of an office building in Norway is performed to demonstrate and document the performance of this type of roof construction. Through monitoring of moisture and temperature, the study aims to contribute to verification of simulations and laboratory measurements showing that unventilated wood-frame roofs may be built with wooden materials if a smart vapour barrier is used. The results show moisture levels below 15 weight-% on the warm side of the rafters throughout the first 15 months of measurements. On the cold side of the rafters, the moisture content increased during winter due to built-in moisture in the construction and reached levels close to 25 weight-%. The moisture content decreased to around 15 weight-% when summer arrived, which shows an expected redistribution of moisture and indicates possible drying of the construction. The measurements underline the importance of limiting built-in moisture to reduce the risk of mould growth, but the study also implies that for some given premises an unventilated pitched wood-frame roof may have acceptable moisture risk.

Water Vapour Resistance of Ceiling Paints—Implications for the Use of Smart Vapour Barriers in Compact Wooden Roofs

“…Smart vapour barriers (SVBs), also called "adaptive vapour barriers", can be used to facilitate drying toward the interior side of the assembly. Hence, SVBs may allow wooden structural elements to be placed within the insulation layer and thus drastically reduce the overall thickness of the building envelope assembly [8,11]. SVBs form a crucial component of compact wooden roofs.…”

“…Buildings 2023, 13, x FOR PEER REVIEW 2 of 13 assembly [8,11]. SVBs form a crucial component of compact wooden roofs.…”

Determining Moisture Content of Laminated Veneer Lumber (LVL)

“…Only one type of electric resistance sensor was used in the research. The main motivation for the research was to establish correlation curves in order to evaluate the moisture performance of the compact wooden roofs with smart vapour barrier pilot projects Sveabakken (Bunkholt et al, 2020) and ZEB Laboratory (Bunkholt et al, 2021). The roofs of both pilot projects were constructed with LVL beams.…”