Pin-on-disc tribotest of Cr/CrN/CrCN/ZrN multilayer coatings by physical vapour deposition (PVD)

Technological progress in hybrid bearings developed high wear and abrasion resistant materials for rolling elements. The manufacturing process of bearing balls presents new challenges, as nowadays, it requires time-consuming and costly processes. In this frame, the bearing manufacturing industry is demanding improvements in materials, geometry, and processes. This work aims to investigate new abrasive coatings for grinding wheels for Si3N4 ball manufacturing. Tribological pin on disk tests are performed on samples of grinding materials (disk) versus a Si3N4 ball (pin). Two samples of specimens coated with an electrodeposited diamond and diamond-reinforced metal matrix composite are examined to measure the abrasion rate and the wear resistance of Silicon Nitride Si3N4 balls, considering the influence of sliding speed and the effect of coating deposition on diamond particle density and granulometry. The measurements estimated the specific wear coefficient k, the height wear surface h, and the wear rate u of the Si3N4 balls. The results pointed out that by increasing the sliding speed, the abraded volume increases for both the coatings. The parameters affecting the abrasion effectiveness of both the coatings are the surface roughness, the abrasive particle dimension, and the sliding speed.

show abstract

“…DMMC durability in aggressive abrasive conditions has been studied [20]. This technique also applies well to multilayer coatings [27].…”

Section: Introductionmentioning

confidence: 99%