Photothermal electric battery based on silicon solar cells

Tursunov, M. N.; Muminov, R. A.; Tukfatullin, O. F.; Yuldoshev, I. A.; Abdullaev, E. T.

doi:10.3103/s0003701x11010166

Cited by 14 publications

(5 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…For the year, the specific production of electric energy of a photovoltaic installation (PVI) is determined by summing up the monthly production values, found in turn, based on the hourly calculation of electric energy production for each average day of the month. The annual generated electric production of the PVI (W0) depends on the operating conditions: time of day, location (climatic zone), condition of the PVB working surface, etc [15][16][17].…”

Section: Resultsmentioning

confidence: 99%

The effect of the surface geometry of a photovoltaic battery on its efficiency

et al. 2020

View full text Add to dashboard Cite

Discusses the influence of the shape of the geometric surface of a photovoltaic battery (PVB) on its effectiveness. The features of photovoltaic systems based on silicon modules with different geometric shapes are considered. Expressions are given for determining the seasonal electric power generation of the PVB considering its surface geometry located in the parking lot, as well as calculations, are made to determine the optimal angle of inclination of the PVB to the horizontal surface under the conditions of the city of Tashkent.

show abstract

Section: Resultsmentioning

confidence: 99%

The effect of the surface geometry of a photovoltaic battery on its efficiency

et al. 2020

View full text Add to dashboard Cite

show abstract

“…A typical anemometer and wind direction meter are used to measure wind characteristics. Additionally, the ambient temperature is measured [31][32][33][34][35][36][37][38][39][40].…”

Section: Discussionmentioning

confidence: 99%

Study of Solar Radiation and Wind Characteristics in Various Regions of Uzbekistan

Saitov

Sobirov²,

Yuldoshev

et al. 2020

E3S Web Conf.

View full text Add to dashboard Cite

The article discusses methods for monitoring solar radiation and wind characteristics and practical principles of use. The efficiency of using solar and wind energy largely depends on how accurately the design took into account specific data on the arrival of solar radiation or wind speed at the site of the intended operation of installations. The instability of the primary energy supply makes it necessary to supply the installations with accumulators, the choice of capacity of which also affects the size of the energy receivers, and therefore the technical and economic indicators.

show abstract

“…Where, Ki= 0,0017A/C, β-lighting, T -temperature. The series resistance Rs and the reverse saturation current Is depend on the manufacturing technology of the SC and strongly affect its characteristics (Fig.5, 6): with increasing Rs and Is, the fill factor FF and the maximum power Pmax decrease [31][32][33][34][35] A mathematical model describes a real object only with a certain degree of approximation. During the simulation, testing and verification of the results of SB simulation was performed.…”

Section: Dependence Of the Iph Of The Sc On Temperature And Lighting mentioning

confidence: 99%

Optimal model for additional operation of the storage system for photovoltaic wind power plants

Saitov¹

2020

E3S Web Conf.

View full text Add to dashboard Cite

This paper discusses methods for modeling and optimizing photovoltaic and wind power plants for the integrated use of solar and wind energy. The results of modeling the dependence of the characteristics of the solar battery and wind power plants on the input parameters are presented. Changes in the output volt-ampere and power parameters depending on environmental conditions are considered. Various programming methods for mathematical modeling of power plants are presented. Methods for optimizing the output characteristics of solar cells by connecting shunt diodes are presented. The operation of solar panels is analyzed on the basis of mathematical modeling of processes. The influence of weather conditions, temperature, and light on the output parameters of solar installations was studied. The advantages of integrated use of solar and wind installations with an energy storage system are also considered. We consider the prediction of wind speeds based on various distribution functions.

show abstract

Photothermal electric battery based on silicon solar cells

Cited by 14 publications

References 0 publications

The effect of the surface geometry of a photovoltaic battery on its efficiency

The effect of the surface geometry of a photovoltaic battery on its efficiency

Study of Solar Radiation and Wind Characteristics in Various Regions of Uzbekistan

Optimal model for additional operation of the storage system for photovoltaic wind power plants

Contact Info

Product

Resources

About