Photocatalytic Degradation of Water Contaminants in Multiple Photoreactors and Evaluation of Reaction Kinetic Constants Independent of Photon Absorption, Irradiance, Reactor Geometry, and Hydrodynamics

Abstract

The literature on photocatalytic oxidation of water pollutants often reports reaction kinetic constants, which cannot be unraveled from photoreactor type and experimental conditions. This study addresses this challenging aspect by presenting a general and simple methodology for the evaluation of fundamental "intrinsic" reaction kinetic constants of photocatalytic degradation of water contaminants, which are independent of photoreactor type, catalyst concentration, irradiance levels, and hydrodynamics. The degradation of the model contaminant, oxalic acid (OA) on titanium dioxide (TiO2) aqueous suspensions, was monitored in two annular photoreactors (PR1 and PR2). The photoreactors with significantly different geometries were operated under different hydrodynamic regimes (turbulent batch mode and laminar flow-through recirculation mode), optical thicknesses, catalyst and OA concentrations, and photon irradiances. The local volumetric rate of photon absorption (LVRPA) was evaluated by the six-flux radiation absorption-scattering model (SFM). The SFM was further combined with a comprehensive kinetic model for the adsorption and photodecomposition of OA on TiO2 to determine local reaction rates and, after integration over the reactor volume, the intrinsic reaction kinetic constants. The model could determine the oxidation of OA in both PR1 and PR2 under a wide range of experimental conditions. This study demonstrates a more meaningful way for determining reaction kinetic constants of photocatalytic degradation of water contaminants.

Photoelectrochemical cell for simultaneous electricity generation and heavy metals recovery from wastewater

“…This fluid was added to a mixture of 18 mL stock solution with 25 mL ethanol at 70 °C. After cooling to room temperature, the liquid paste was immobilized on an ITO glass (area 2.25 cm 2 ) by doctor-blade technique as reported elsewhere [22,23]. After coating the films were kept in a clean box for 15 min to relax surface irregularities and the residual mechanical stress of the coating.…”

Photocatalytic Activity of TiO2 Thin Films: Kinetic and Efficiency Study

“…When it is used to measure the irradiance from blacklight UV-A lamps the readings should be multiplied by a factor equal to 1.54 to ascertain the true value. This correction was elaborated previously (Grčić and Li Puma 2013). Used blacklight UV-A lamps were considered as sources of pseudo-monochromatic irradiation (365 nm) and calculations were performed accordingly.…”

Modelado y evaluación experimental de un reactor solar fotocatalítico no isotérmico: efecto de la temperatura sobre la cinética de la velocidad de reacción

“…Typically, the interpretation of the experimental results is based on t 30w (19), the treatment time (20), the incident radiation within the reactor, and the photon flux absorbed by the catalyst. However, these parameters interact and yield erroneous conclusions, which is impractical given that the reactor is comprised of illuminated and non-illuminated areas.…”