Performance of Siloxane Mixtures in a High-Temperature Organic Rankine Cycle Considering the Heat Transfer Characteristics during Evaporation

Abstract

Abstract:The application of the Organic Rankine Cycle to high temperature heat sources is investigated on the case study of waste heat recovery from a selected biogas plant. Two different modes of operation are distinguished: pure electric power and combined heat and power generation. The siloxanes hexamethyldisiloxane (MM) and octamethyltrisiloxane (MDM) are chosen as working fluids. Moreover, the effect of using mixtures of these components is analysed. Regarding pure electricity generation, process simulations using the simulation tool Aspen Plus show an increase in second law efficiency of 1.3% in case of 97/03 wt % MM/MDM-mixture, whereas for the combined heat and power mode a 60/40 wt % MM/MDM-mixture yields the highest efficiency with an increase of nearly 3% compared to most efficient pure fluid. Next to thermodynamic analysis, measurements of heat transfer coefficients of these siloxanes as well as their mixtures are conducted and Kandlikar's correlation is chosen to describe the results. Based on that, heat exchanger areas for preheater and evaporator are calculated in order to check whether the poorer heat transfer characteristics of mixtures devalue their efficiency benefit due to increased heat transfer areas. Results show higher heat transfer areas of 0.9% and 14%, respectively, compared to MM. OPEN ACCESSEnergies 2014, 7 5549

Thermal Stability of Hexamethyldisiloxane (MM) for High-Temperature Organic Rankine Cycle (ORC)

“…Guillen et al [10] and Bei et al [11] also develop direct contact evaporators for high temperatures. Weith et al [12] investigate heat transfer characteristics of siloxanes including MM which are necessary for accurate heat exchanger design.…”

Biogas Engine Waste Heat Recovery Using Organic Rankine Cycle

“…Pure fluids are good working medium candidates, but as presented in several works (see, e.g., [77][78][79]), also zeotropic mixtures are suitable candidates due to their non-isothermal phase transitions during vaporization and condensation. For this reason, the possibility of adopting the mixture is also included in the tool.…”

Thermoeconomic Evaluation of Modular Organic Rankine Cycles for Waste Heat Recovery over a Broad Range of Heat Source Temperatures and Capacities

“…Multi-stage ORCs and the usage of a regenerator cause higher complexity and higher effort for measurement and control of the Based on the literature described in the previous section, a single-stage ORC with internal recuperator in sub-and supercritical mode of operation is chosen for subsequent analysis. Pure fluids are used, as fluid mixtures lead to a significant increase in heat exchange area [61]. The IR increases the thermal efficiency for dry working fluids and reduces the cooling of the heat source so that acid formation is inhibited which can be crucial for industrial waste heat flows.…”