Performance of multi-hop cognitive MIMO relaying networks with joint constraint of intercept probability and limited interference

Abstract

In this paper, we propose a multi-hop multiple input multiple output (MIMO) decode-and-forward relaying protocol in cognitive radio networks. In this protocol, a multi-antenna secondary source attempts to send its data to a multiantenna secondary destination with assistance of multiple intermediate multiantenna nodes, in presence of a multi-antenna secondary eavesdropper. A primary network includes a primary transmitter and a primary receiver which are equipped with multiple antennas, and use transmit antenna selection (TAS) and selection combining (SC) to communicate with each other. Operating on the underlay spectrum sharing method, the secondary source and relay nodes have to adjust their transmit power so that the outage performance of the primary network is not harmful and satisfy the quality of service (QoS). Moreover, these secondary nodes also reduce their transmit power so that the intercept probability (IP) at the eavesdropper at each hop is below a desired value. To improve the outage performance of the secondary network under the joint constraint of IP and limited interference, the TAS/SC method is employed to relay the source data hop-by-hop to the destination. We derived exact closed-form expressions of the end-to-end (e2e) outage probability (OP) and IP of the proposed protocol over Rayleigh fading channels. Monte Carlo simulations are then performed to verify the theoretical derivations.

IoT Short-Packet URLLCs for MIMO Underlay Cognitive Multihop Relaying with Imperfect CSI

“…By applying (15) and (16) to Proposition 3, the closedform expression for the asymptotic BLER at link k is given by εS,Near k ∼ = F S,Near γ k (θ) . Eventually, similar to (10), the asymptotic E2E BLER for scheme S in the near-CR asymptotic regime is obtained as εS,Near…”

Convertible Bandstop to Allpass Filter using Defected Ground Structure with Ideal Switch for Millimeter-Wave Band in 5G Application

“…It is clear from (3) that the L and C components are responsible for the bandstop's notch if Z0 = 1 which is a normalize impedance. After that, the DGS's resonance frequency can be discovered when (4) Thus, (5) where f0 is the resonant frequency in Hertz. The S21 in (3) at OFF state also determined by condition in (4) and thus becomes (6) It is clear from ( 6) that a bandstop response can be constructed with optimally high attenuation.…”

“…The FSS satellite, however, experiences interruption via numerous IMT-2020s (5G communication standard) in the mm-wave frequencies, illustrated in [2], and therefore this novel approach will clash with today's technology. as well as enhancing the utilisation of the unoccupied radio spectrum [4], multi-hop multiple input multiple output (MIMO) decode-and-forward transmitting processes [5], interruption management techniques for device-to-device (D2D) applications [6], and ultra-wideband.…”