Performance evaluation of a micro‐CT system for laboratory animal imaging with iterative reconstruction capabilities

Abstract

Background: In recent years, there has been a rapid proliferation in micro-computed tomography (micro-CT) systems becoming more available for routine preclinical research, with applications in many areas including bone, lung, cancer and cardiac imaging. Micro-CT provides the means to noninvasively acquire detailed anatomical information, but high-resolution imaging comes at the cost of longer scan times and higher doses, which is not desirable given the potential risks related to x-ray radiation. To achieve dose reduction and higher throughputs without compromising image quality (noise management), fewer projections can be acquired. This is where iterative reconstruction methods can have the potential to reduce noise since these algorithms can better handle sparse projection data, compared to filtered backprojection Purpose: We evaluate the performance characteristics of a compact benchtop micro-CT scanner that provides iterative reconstruction capabilities with GPU-based acceleration. More specifically, we thereby investigate the potential benefit of iterative reconstruction methods for dose reduction.Methods: Based on a series of phantom experiments, the benchtop micro-CT system was characterized in terms of image uniformity, noise, low contrast detectability, linearity and spatial resolution. Whole-body images of a plasticized ex vivo mouse phantom were also acquired. Different acquisition protocols (general-purpose versus high-resolution, including low dose scans) and different This article is protected by copyright. All rights reserved. 3 reconstruction strategies (analytic versus iterative algorithms: FDK, ISRA, ISRA-TV) were compared.Results: Signal uniformity was maintained across the radial and axial field-of-view (no cupping effect) with an average difference in Hounsfield units (HU) between peripheral and central regions below 50. For low contrast detectability, regions with at least ∆HU of 40 to surrounding material could be discriminated (for rods of 2.5 mm diameter). A high linear correlation (R 2 = 0.997) was found between measured CT values and iodine concentrations (0-40 mg/ml). Modulation transfer function (MTF) calculations on a wire phantom evaluated a resolution of 10.2 lp/mm at 10% MTF that was consistent with the 8.3% MTF measured on the 50 µm bars (10 lp/mm) of a bar-pattern phantom. Noteworthy changes in signal-to-noise and contrast-to-noise values were found for different acquisition and reconstruction protocols. Our results further showed the potential of iterative reconstruction methods to deliver images with less noise and artefacts. Conclusions:In summary, the micro-CT system for laboratory animal imaging that was evaluated in the present work was shown to provide a good combination of performance characteristics between image uniformity, low contrast detectability and resolution in short scan times. With the iterative reconstruction capabilities of this micro-CT system in mind (ISRA and ISRA-TV), the adoption of such algorithms by GPU-based acceleration enables the integration of no...

Cone-beam x-ray luminescence computed tomography (CB-XLCT) prototype development and performance evaluation

“…The performance analysis results of the prototype CT system were compared with two commercial micro-CT systems, the DELPet-μCT manufactured in Taiwan in 2020 (Lo et al 2020), and the X CUBE produced in 2022 (Muller et al 2022), using the same analysis methods. The results are presented in table 4.…”

Image Denoising of Low-Dose PET Mouse Scans with Deep Learning: Validation Study for Preclinical Imaging Applicability

“…Dose reduction strategies with DL denoising are also applicable in micro-CT imaging. In our previous work [19] a neural network was trained and evaluated for denoising low dose micro-CT acquisitions to realize higher quality micro-CT imaging at reduced doses (by a factor of 3). In preclinical research, low dose multi-modality studies offer promising future prospects for managing the cumulative effects of radiation in longitudinal imaging studies.…”

Dose reduction and image enhancement in micro‐CT using deep learning

“…All micro‐CT data was obtained from the X‐CUBE (Molecubes, Ghent, Belgium), a benchtop micro‐CT system 34 . In total 38 mice were scanned by ex vivo whole‐body spiral micro‐CT.…”

“…All micro-CT data was obtained from the X-CUBE (Molecubes, Ghent, Belgium), a benchtop micro-CT system. 34 In total 38 mice were scanned by ex vivo wholebody spiral micro-CT. Acquired projection datasets were reconstructed iteratively (GPU-based ISRA) with 200 μm voxel size. Note that 200 μm voxels were chosen because of practical storage size and reconstruction time, but also, although the spatial resolution of the X-CUBE system is in the 50 μm range, it is quite common to reconstruct micro-CT images at 200 μm resolution especially for multi-modality imaging with preclinical CT. Two different scan settings, General-Purpose (GP) and High-Resolution (HR) protocols predefined on the X-CUBE, were selected to acquire the LD and HD scans, respectively.…”