Performance Analysis of Data Transmission on a Wireless Sensor Network Using the XBee Pro Series 2B RF Module

Abstract

Wireless Sensor Network (WSN) is a wireless network technology that is capable of scanning and can be used to monitor environmental conditions, both indoors and outdoors. One of the devices used in data communication at WSN is XBee. XBee is a device in WSN that uses radio frequency as a data transmission path from one device to another. In sending data, Xbee can be affected by the distance and signal strength between devices. In this research, Xbee communication distance analysis is done outdoors and indoors so as to get data in the form of maximum distance vulnerable from Xbee. The results of this study indicate that the Xbee Pro Series 2B that is measured outside the room is capable of sending data up to a distance of 110 meters, while the Xbee Pro Series 2B device that is measured indoors is capable of sending data up to a distance of 20 meters.

The Influence of Sports Dance on the Physical and Mental Development of Contemporary College Students Based on Health Detection

“…As the center of the entire network, the wireless AP needs to communicate with other applications. Many STA devices are built in to create these wireless networks, while basic AP-based wireless networks are created by APs [ 19 ]. The basic network topology is shown in Figure 3 .…”

Rancang Bangun Tempat Sampah Pintar Untuk Meningkatkkan Management Sampah Berbasis Mikrokontroler

“…Metode dalam melakukan pengumpulan data pada tempat sampah pintar menggunakan metode pengumpulan data sekunder. Metode pengumpulan data sekunder merupakan metode yang dilakukan dari pengumpulan data yang dilakukan secara tidak langsung yaitu dapat berupa buku yang berkaitan dengan penelitian yang dilakukan [11] [12].…”

The Effect of The Addition of Mealworm Frass (Tenebrio Molitor) and Molasses on the Increasing of the Proximate Value of White Oyster Mushroom (Pleurotus Ostreatus)

“…Inoculation was carried out by opening the bag log cover and bringing the end of the bag log closer to the bunsen burners then the F2 mushroom seeds (Muslimin et al, 2021) were inserted into it through the middle of the Parallon ring in the media. Incubation of the oyster mushroom bag log was carried out until all white (mycelium-grown) media (bag log) filled the bag log evenly and was then transferred to the mushroom house which was installed with the temperature and humidity controlled (Desnanjaya & Sugiartawan, 2022). The observed parameters were the growth of oyster mushrooms.…”