Peculiarities of metal surface abrasive jet processing before coloring

Кульков, Анатолий; Кульков, А.Н.; Larionov, Maksim

doi:10.30987/article_5bf7a56d3dab40.87032409

Cited by 5 publications

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…Различают фактический передний угол γ ф , измеряемый в сечении перпендикулярном оси вращения фрезы, и нормальный передний угол γ н , измеряемый в сечении нормали к направлению главной режущей кромки. С увеличением угла наклона режущей пластины λ разница между фактическим передним углом γ ф и передним углом в нормальном сечении γ н резко возрастает [3].…”

Section: рис 5 схема проектированияunclassified

Design of tool geometrical form for milling

Куликов¹,

Волков²,

Волков³

2018

Science Intensive Technologies in Mechanical Engineering

View full text Add to dashboard Cite

show abstract

Section: рис 5 схема проектированияunclassified

Design of tool geometrical form for milling

Куликов¹,

Волков²,

Волков³

2018

Science Intensive Technologies in Mechanical Engineering

View full text Add to dashboard Cite

show abstract

Ensuring the Quality of Pre-Painting of the Car Lining Surface by the Gas-Dynamic Method

Кульков

2023

Transport Engineering

View full text Add to dashboard Cite

The regularities of ensuring the quality of the metal lining surface of the of railway car bodies before the operation of factory or repair painting are described. The gas-dynamic method given in this paper can significantly improve the efficiency and quality of surface preparation for painting. The results of the study of particles acceleration in a gas-dynamic flow are presented, the process of abrasive particles collision with the surface, the degree of cleaning of the car metal lining, and the surface roughness after treatment are researched. The influence of all the above factors on the quality of the pre-painting is described. The relevance of this study is determined by the high requirements of manufacturers of paint and varnish materials for the quality of pre-painting of metal surfaces.

show abstract

Modeling of the Manufacturing Process of Pre-Paint Treatment of Railway Equipment Body Covering

Kul'kov,

Larionov,

Razinkov

2024

Transport Engineering

View full text Add to dashboard Cite

There are data on the mathematical modeling of the manufacturing process of gas dynamic treatment. The study objective is to obtain a mathematical apparatus that allows the calculation of the main manufacturing modes of gas dynamic treatment according to the destruction rate of operational pollution, as well as to the invasiveness of the body covering. To do this, the paper presents the main provisions of the mathematical model and the results of the research.

show abstract

Peculiarities of metal surface abrasive jet processing before coloring

Cited by 5 publications

References 0 publications

Design of tool geometrical form for milling

Design of tool geometrical form for milling

Ensuring the Quality of Pre-Painting of the Car Lining Surface by the Gas-Dynamic Method

Modeling of the Manufacturing Process of Pre-Paint Treatment of Railway Equipment Body Covering

Contact Info

Product

Resources

About