Parametric Study on the Operating Efficiencies of a Packed Bed for High-Temperature Sensible Heat Storage

Abstract

A comprehensive computer model of a packed bed thermal energy storage system originally developed for storage media employing either sensible heat storage (SHS) materials or phase-change material (PCM), was validated for the sensible heat storage media using a rather extensive set of data obtained with a custom-made experimental facility for high-temperature energy storage. The model is for high-temperature storage and incorporates several features including (a) allowance for media property variations with temperature, (b) provisions for arbitrary initial conditions and time-dependent varying fluid inlet temperature to be set, (c) formulation for axial thermal dispersion effects in the bed, (d) modeling for intraparticle transient conduction in the storage medium, (e) provision for energy storage (or accumulation) in the fluid medium, (f) modeling for the transient conduction in the containment vessel wall, (g) energy recovery in two modes, one with flow direction parallel with that in the storage mode (cocurrent) and the other with flow in the opposite direction (countercurrent), and (h) computation of the first and second-law efficiencies. Parametric studies on the sensible heat storage system were carried out using the validated model to determine the effects of several of the design and operating parameters on the first and second-law efficiencies of the packed bed. Decisions on the thermodynamic optimum system design and operating parameters for the packed bed are based on the second-law evaluations made

Parametric analysis of a high temperature packed bed thermal storage design for a solar gas turbine

“…The effects of gas radiation and intra-particle conduction were studied. The convective heat transfer correlations of Bradshaw et al (1970) and Wakao and Kaguei (1982) were found to be suitable up to a temperature of 960 C. Adebiyi et al (1998) also presented a numerical model of this zirconia TES system which was validated against experimental data up to a temperature of 800 C. The model was further used to conduct a parametric analysis of the system based on first and second law efficiency metrics.…”

“…The density of the high alumina spheres is between 3.6 kg/m 3 and 3.9 kg/m 3 , depending on the purity and sintering process. Zirconia was advocated by Jalalzadeh-Azar et al (1996) and Adebiyi et al (1998) as an efficient high temperature thermal storage medium. Yttria stabilised zirconia has a density of between 5.4 kg/m 3 and 6 kg/m 3 .…”

A review on thermal energy storage systems in solar air heaters

“…The results reported that the v‐corrugated heater with PCM storage had delivered higher outlet air temperature during off‐sunshine hours. Adebiyi et al developed computer model for packed bed thermal energy storage system. Encapsulated PCM pellets containing zirconium oxide for both charging and discharging process of thermal storage was used.…”

Numerical Investigation of Packed Bed Thermal Energy Storage Systems with Prediction based Adjustment of the Heat Transfer Fluid Flow

“…Many published works (see e.g. [8,[10][11][12][13][14].) refer for numerical investigations to the mathematical PDE model originally developed by Schumann [12].…”