2020
DOI: 10.1103/physrevapplied.14.064007
|View full text |Cite
|
Sign up to set email alerts
|

Parabolic Diamond Scanning Probes for Single-Spin Magnetic Field Imaging

Help me understand this report
View preprint versions

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1

Citation Types

0
41
0

Year Published

2021
2021
2024
2024

Publication Types

Select...
6
2

Relationship

3
5

Authors

Journals

citations
Cited by 35 publications
(41 citation statements)
references
References 43 publications
0
41
0
Order By: Relevance
“…Specifically, we use state-dependent fluorescence to identify the Zeeman splitting between the |±1 spin levels using optically detected magnetic resonance (ODMR). All measurements in this study were performed using scanning, all-diamond parabolic pillars [41] housing a single NV center and integrated into a custom confocal imaging setup equipped with a CW 532 nm laser [42]. The measurements were performed with <10 µW of continuous-wave optical excitation, a factor of two smaller than typical saturation powers for NVs in these parabolic scanning pillars [41].…”
Section: Nv Magnetometrymentioning
confidence: 99%
See 1 more Smart Citation
“…Specifically, we use state-dependent fluorescence to identify the Zeeman splitting between the |±1 spin levels using optically detected magnetic resonance (ODMR). All measurements in this study were performed using scanning, all-diamond parabolic pillars [41] housing a single NV center and integrated into a custom confocal imaging setup equipped with a CW 532 nm laser [42]. The measurements were performed with <10 µW of continuous-wave optical excitation, a factor of two smaller than typical saturation powers for NVs in these parabolic scanning pillars [41].…”
Section: Nv Magnetometrymentioning
confidence: 99%
“…All measurements in this study were performed using scanning, all-diamond parabolic pillars [41] housing a single NV center and integrated into a custom confocal imaging setup equipped with a CW 532 nm laser [42]. The measurements were performed with <10 µW of continuous-wave optical excitation, a factor of two smaller than typical saturation powers for NVs in these parabolic scanning pillars [41]. The microwave (MW) needed to manipulate the NV is provided by a 30 µm gold loop antenna with a typical effective driving strength of 0.25 G at the NV.…”
Section: Nv Magnetometrymentioning
confidence: 99%
“…The NV spectrum is obtained with a spectrograph (Princeton Instruments, 12. Optical emission spectrum of a single NV in a diamond nanostructure [22,24]. The highlighted regions indicate the regions of collected PL to separate the slightly overlapping spectra of the charge states NV 0 (orange) and NV − (red).…”
Section: Experimental Apparatusmentioning
confidence: 99%
“…These two types of NV defects were chosen for studying a broad range of local strain, which is known to be increased for NVs implanted close to the diamond surface [21]. To enhance NV PL collection efficiencies, diamond solid immersion lenses and nanopillars were structured on samples S1 and S2, respectively, with methods reported elsewhere [22][23][24].…”
mentioning
confidence: 99%
“…Although this scheme works well for slow acquisition speeds, the non-linear least squares fitting of the spectrum is computationally expensive and ill-suited for real-time performance past a few Hz. On the other hand, the high PL of modern NV tips [28,29] should allow measurements of magnetic fields at rates of 100 Hz or faster while maintaining a high sensitivity below 10 µT. The possibility of acquiring a scan in a matter of minutes rather than hours or days is enticing, and would further bolster the versatility of the * degenc@ethz.ch; † These authors contributed equally.…”
Section: Introductionmentioning
confidence: 99%