Oxygen pressure effects on optical properties of ZnO prepared by reactive puled laser deposition

Mohammed, Q.; Badr, Ban A.; Banoosh, Amal M.; Fakhri, Makram A.; Abdulwahab, Ahmed W.

doi:10.1063/5.0000202

Cited by 16 publications

(6 citation statements)

References 41 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The optical energy gap of ZnO was determined to be 3.28 eV, which is somewhat smaller than the bulk energy gap of 3.32 Ev. according to other results [45] and is consistent with other published work of the same films [46]. Using the handmade measuring stage presented in our previous work, we measured the thermal and electrical properties of the device.…”

Section: Engineering Materials and Innovative Technologiessupporting

confidence: 91%

Conductivity Modification of ZnO NRs Films via Gold Coating for Temperature Sensor Application

Faisal

Khalef

Salim

et al. 2022

KEM

View full text Add to dashboard Cite

Zinc oxide nanorods zinc oxide nanowire has been deposited on quartz employing a hydrothermal method. The ZnO nanoroad as a seed layer were prepared for the growth process using the drop-casting method. The zincoxide nanomaterials produced were characterized by UV–Visible spectrophotometers, x-ray diffraction, Scanning electron microscopy ,. The crystal structure was calculated from the XRD data and it was confirmed the growth of wurtzite crystalline crystal structures of ZnO NRs. The SEM images revealed high-density nanowires were grown via drop cast coated seed layer. The bandgap in the ZnO NRs film was found to be 3.28 eV. This result was confirmed the formation of ZnO nanostructure. The thermal and electrical properties of ZnO NRs were measured also and analyzed. The conductivity of the ZnO NRs film was modified with the addition of gold nanoparticles using the sputtering technique. These modified films were promising and give an optimized temperature sensor performance.

show abstract

Section: Engineering Materials and Innovative Technologiessupporting

confidence: 91%

Conductivity Modification of ZnO NRs Films via Gold Coating for Temperature Sensor Application

Faisal

Khalef

Salim

et al. 2022

KEM

View full text Add to dashboard Cite

show abstract

“…All of the heterojunction versions had acceptable ratification features, indicating the development of a diode-like device [39][40][41][42][43]. The current value at the biasing of forward was dramatically multiplied by the voltage biasing value, where the measured currents are extremely little at the biasing voltage value is very small, these values of currents are called the current of the recombination, while the current of the diffusion values must be controlled at the high biasing voltage>1 V [44][45][46]. The synthetic heterojunction created and deposited at high pulsed laser energy produces a greater current value at forward bias because of low value of resistivity for the Nano-copper oxide layer, as shown in the figure below.…”

Section: Resultsmentioning

confidence: 99%

Visible Ranges Photo Detector Fabricated Based on Nano Copper Oxide Deposited by Reactive Pulsed Laser Deposition

Alshaikhli

Alhasan

Salim

et al. 2022

DDF

View full text Add to dashboard Cite

This manuscript presents the reactive pulsed laser deposition method was used to prepare and deposit the high-quality copper oxide (Cu2O) Nanofilms using high purity copper metal, Oxygen, and heating at 300 C, at different laser energies rated (800 mj, 1000 mj, and 1200 mj) respectively. The presented results show high ranges of transparent values with the increasing laser energies from 66%-90%. As the laser energies increased the optical energy band gap value was increased from 2.32eV – 2.47eV. Further, the AFM, XRD, I-V, and spectral response tasted and investigated the surface topography, homogeneity, roughness’s, structural and optoelectronic properties for the deposited Cu2O nanofilms, respectively.

show abstract

“…The parameters that characterize the deposited film structure were characterized by an analysis of the X-ray diffraction results using the presented following formulas [40][41][42][43][44]:…”

Section: Resultsmentioning

confidence: 99%

Silver Oxide Nanostructure: a Study on Physical Properties at Different Chemical Interaction Time

2021

Preprint

View full text Add to dashboard Cite

Chemical bath deposition method was employed for the deposition of smooth quantum size Ag2O nanostructure thin film on glass substrate at three different chemical interaction times. The structural properties shows the demonstration of Ag2O cubic structure at (002) diffraction plane. Optical properties reflect the dependence of energy gab on the interaction time with moderate band gab energy of about 2.25eV.Other physical properties such as SEM, AFM, was also investigated.

show abstract

Oxygen pressure effects on optical properties of ZnO prepared by reactive puled laser deposition

Cited by 16 publications

References 41 publications

Conductivity Modification of ZnO NRs Films via Gold Coating for Temperature Sensor Application

Conductivity Modification of ZnO NRs Films via Gold Coating for Temperature Sensor Application

Visible Ranges Photo Detector Fabricated Based on Nano Copper Oxide Deposited by Reactive Pulsed Laser Deposition

Silver Oxide Nanostructure: a Study on Physical Properties at Different Chemical Interaction Time

Contact Info

Product

Resources

About