“…The formation of low viscosity borosilicate glass on the surface of the coating steps from this process, and it will spread along surface of the coating rapidly. Hence, the partial pressure of oxygen is low in the inner part of the coating, which would result in the active oxidation of SiC (SiC + O 2 → SiO + CO) and the evaporation of SiO in return [19,25,34]. This oxidation mechanism is distinctively different from that of pure SiBCN.…”
Section: Oxidation Resistance Of the Coating At 1773 Kmentioning
confidence: 96%
“…When oxidized at medium temperature (1273-1473 K), borosilicate glass shows low viscosity and high wettability. It can seal cracks in the coating effectively and inhibit further oxidation [9][10][11][17][18][19]. At high temperature (1473-1773 K), the high-thermally stable ZrSiO 4 phase which is formed by the reaction between ZrO 2 and SiO 2 , can improve the stability of silica glass and lower the diffusion rate of oxygen [20][21][22].…”
“…The formation of low viscosity borosilicate glass on the surface of the coating steps from this process, and it will spread along surface of the coating rapidly. Hence, the partial pressure of oxygen is low in the inner part of the coating, which would result in the active oxidation of SiC (SiC + O 2 → SiO + CO) and the evaporation of SiO in return [19,25,34]. This oxidation mechanism is distinctively different from that of pure SiBCN.…”
Section: Oxidation Resistance Of the Coating At 1773 Kmentioning
confidence: 96%
“…When oxidized at medium temperature (1273-1473 K), borosilicate glass shows low viscosity and high wettability. It can seal cracks in the coating effectively and inhibit further oxidation [9][10][11][17][18][19]. At high temperature (1473-1773 K), the high-thermally stable ZrSiO 4 phase which is formed by the reaction between ZrO 2 and SiO 2 , can improve the stability of silica glass and lower the diffusion rate of oxygen [20][21][22].…”
“…Briefly, MgCO 3 (99% purity, BulkSupplements) and Al(OH) 3 (99% purity, Alpha Chemicals) powders with molar ratio of 1:2 were mechanically activated for 6 h in a planetary ball mill (Across International, PQ-N2) in air at ambient temperature and then the ball milled powders were heat treated at 1200°C for 1 h in a tube furnace (MTI Corporation, GSL 1700x) to produce single-phase spinel. The obtained spinel powder was uniaxially pressed into cylindrical pellets with the height and diameter of 12 Â 12 mm in a hardened steel mold at a pressure of 200 MPa using 10 wt% glycerol binder.…”
Section: Preparation Of Spinel Specimensmentioning
confidence: 99%
“…Ceramics with crack-healing ability can prevent catastrophic failure of structures, and subsequently increase the reliability of the structures in service [1][2][3][4][5].…”
“…Anti-oxidation coatings, which may be based on carbides [7][8][9], silicides [10,11] or oxides [12][13][14], was a key technique for advanced composites.…”
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.