Overview — Simulation of Sheet Metal Forming

Abstract

Jet and particle production have been studied in collisions of quasi-real photons collected during the LEP2 program. OPAL and DELPHI report good agreement of NLO perturbative QCD with the measured differential di-jet cross sections, which reach a mean transverse energy of the di-jet system of 25 GeV. L3, on the other hand, finds drastic disagreement of the same calculation with single jet production for transverse jet momenta larger than about 25 GeV. L3 observes similar disagreement between data and NLO QCD in their measurements of charged and neutral particle production at high transverse momenta of the particles. A recent measurement performed by DELPHI of the same quantities does not confirm this observation.PACS numbers: 13.60.Hb Total and inclusive cross sections (including deepinelastic processes) 14.70.Bh Photons 13.66.Bc Hadron production in e + e − interactions

Integrating effect of forming in fatigue life prediction: review of present scenario and challenges

“…1. As discussed, the major application of sheet metal forming simulation is for the tooling industry 113,114 and as a result, formability of the component rather than the functionality of the component has gained primary importance. 82 2.…”

A Review of Characterization and Modelling Approaches for Sheet Metal Forming of Lightweight Metallic Materials

“…Afterwards, Toh et al [ 85 ] also introduced a general approach to 3D sheet metal simulation. In these simulations, either a static implicit or explicit method was utilized [ 64 , 65 ] with elasto-plasticity as a material model [ 66 ]. Later, deformation mechanics were introduced to DYNA3D FE software by Benson et al [ 86 ].…”

“…Makinouchi et al [ 61 ] presented the current status and progress of SMF simulations in industries in Japan, Europe and the United States. Tekkaya [ 62 ], Tisza [ 63 ] and Wenner [ 64 ] presented developments and progress in SMF simulations in terms of methodologies, type of element and the available FE software before 2005. Ahmed et al [ 65 ] presented the progress of SMF simulations from several points of view, such as continuum and shell approaches, material and geometrical non-linearity and frictional contact.…”

Aplicação Do Diagrama De Ishikawa Visando a Orientação De Produtores De Leite: Estudo De Caso No Centro Oeste Paulista

“…Constitui de um processo tecnológico de conformação plástica de chapa, com o qual é possível obter grande variedade de peças com relevante complexidade e ocas (WENNER, 2005).…”