Osgood Schlatter's disease in young basketball players

Jakovljević, Aleksandar; Grubor, Predrag; Simović, Slobodan; Bijelić, Snežana; Maran, Milorad; Kalacun, Dario

doi:10.5550/sgia.1002074

Cited by 2 publications

(2 citation statements)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…[1] of the paper the lamp was joined by traditional techniques, the technology was validated and then in the second part of the paper it was tried to obtain it by FDM (Table 1). [5] After joining the parts, a series of measurements were made at several important points as shown in Figure 2 to check the quality, all the tests done on the joint had validated the chosen technology. Two types of tests were carried out.…”

Section: Methods Applied In Joiningmentioning

confidence: 99%

See 1 more Smart Citation

Optimization of a Dissimilar Joint Using Additive Manufacturing

Feier,

Brindușoiu,

Nițoi

et al. 2024

Macromolecular Symposia

View full text Add to dashboard Cite

The article will explore a potential additive manufacturing approach for combining two distinct thermoplastics, ABS and PMMA. The obtained piece can be produced up of two parts: the lower half is made of ABS, while the upper part is based on PMMA. Given that the assembly is meant to be used on an automobile's exterior, it must be resilient to air and water. Both types of thermopolymers—ABS and PMMA—must be used in a range of lighting applications, including automotive lighting, to lower prices and improve lamp performance. Although PMMA and ABS are different materials, they are compatible and are frequently bonded together.

show abstract

Section: Methods Applied In Joiningmentioning

confidence: 99%

“…In the first part of the paper the lamp was joined by traditional techniques, the technology was validated and then in the second part of the paper it was tried to obtain it by FDM ( Table 1 ). [ 5 ]…”

Section: Methodsmentioning

confidence: 99%