Optimizing photo-mineralization of aqueous methyl orange by nano-ZnO catalyst under simulated natural conditions

Abstract

BackgroundPhoto-degradation of organic contaminants into non-hazardous mineral compounds is emerging as a strategy to purify water and environment. Tremendous research is being done using direct solar light for these purposes. In this paper we report on optimum conditions for complete mineralization of aqueous methyl orange using lab-prepared ZnO nanopowder catalyst under simulated solar light.ResultsNano-scale ZnO powder was prepared in the lab by standard methods, and then characterized using electronic absorption spectra, photolumenscence emission (PL) spectra, XRD, and SEM. The powder involved a wurtzite structure with ~19 nm particles living in agglomerates. Photo-degradation progressed faster under neutral or slightly acidic conditions which resemble natural waters. Increasing catalyst concentration increased photodegradation rate to a certain limit. Values of catalyst turn over number and degradation percentage increased under higher light intensity, whereas the quantum yield values decreased. The photocatalytic efficiency of nano-ZnO powders in methyl orange photodegradation in water with solar light has been affected by changing the working conditions. More importantly, the process may be used under natural water conditions with pH normally less than 7, with no need to use high concentrations of catalyst or contaminant. The results also highlight the negative impact of possible high concentrations of CO2 on water purification processes. Effects of other added gaseous flows to the reaction mixture are also discussed.ConclusionZnO nano-particles are useful catalyst for complete mineralization of organic contaminants in water. Photo-degradation of organic contaminants with ZnO nano-particles, methyl orange being an example, should be considered for future large scale water purification processes under natural conditions.

Effects of reaction parameters on photodegradation of caffeine over hierarchical flower‐like ZnO nanostructure

“…[1] However, the degradation efficiency was decreased when surpassing the limit value because the suspension is increased, the short wave tail photons are not able to enter the reaction mixture and a decrease in UV light penetration as a result of increased scattering effect. [4,5]…”

Green synthesis of mesoporous anatase TiO2nanoparticles and their photocatalytic activities

“…One possible explanation for such behaviour is that when the photocatalyst amount surpassed 0.1 g, part of the catalyst surface probably became unavailable for photon absorption and dye adsorption under such conditions or deactivation of activated molecules by collision with ground state molecules may occur at higher catalyst loading and thus, bringing little stimulation to catalytic reaction. 30,31 However, the catalyst dosage was further decreased to 0.05 g to determine its degradation efficiency. It is clear that the rate of degradation decrease proportionally with the decrease in the amount of the catalyst.…”

Photocatalytic Activity of ZnO–SnO2 Ceramic Nanofibers for RhB Dye Degradation: Experimental Design, Modeling, and Process Optimization

“…At very low temperature (below 0 °C), adsorption of the molecules (a spontaneous exothermic process) is favored and then desorption of the final products becomes very slowly resulting in an inhibition effect by decrease of active surface of the catalyst particles. When temperature increases above 80 °C, the adsorption of reactants is disfavored and, as a consequence, photocatalytic activity is diminished . Thus, the optimum temperature may be comprised between 20 °C and 80 °C.…”