Optimization of Shunt Active Power Filtering with PI Control in a Three-Phase Three-Wire System

Chaithanakulwat, Arckarakit

doi:10.18280/ejee.220105

Cited by 4 publications

(3 citation statements)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…This prototype consists of a DC voltage capacitor, current filter inductor, IGBT circuit, gate drive circuit, delay circuit, current detection circuit, and a voltage detection circuit. Accordingly, writing commands for processing with the math model function of MATLAB/ Simulink programs into microcontrollers [24][25][26][27][28][29][30][31]. Moreover, active power and reactive power control with vector simplified optimization techniques based on the D-Q spindle reference frame for single-phase grid-connected inverter.…”

Section: Figure 4 the Block Diagram Transfer Functionmentioning

confidence: 99%

Optimized D-Q Vector Control of Single-Phase Grid-Connected Inverter for Photovoltaic System

Chaithanakulwat¹,

Thungsuk²,

Savangboon³

et al. 2021

JESA

Self Cite

View full text Add to dashboard Cite

This paper presents the control of grid-connected single-phase inverters with vector control technology based on the D-Q spindle reference frame for photovoltaic systems. This method begins with converting the grid current of the reference sinusoidal signal to a 90degree phase angle and converting it to a DC signal using the clack conversion principle. The aim of this research is to control the current amount of the D-axis vector and adjust the motion angle lag and lead the Q-axis vector. This mechanism control technology uses a microcontroller TMS3020F28379D This allows control of the inverter modulation to supply active and reactive power to the grid. As a result, the power factor in the system can be controlled close to unity. The simulation results using MATLAB / Simulink, compared to the prototype mechanism can confirm satisfactory accuracy.

show abstract

Section: Figure 4 the Block Diagram Transfer Functionmentioning

confidence: 99%

Optimized D-Q Vector Control of Single-Phase Grid-Connected Inverter for Photovoltaic System

Chaithanakulwat¹,

Thungsuk²,

Savangboon³

et al. 2021

JESA

Self Cite

View full text Add to dashboard Cite

show abstract

“…Insulated-gate bipolar transistor (IGBT) devices with a hysteresis current controller are utilised with analogue cards to generate pulses for usage in inverter applications [12], [13]. In compliance with the recommended IEEE 519-1992 harmonic standard limitations, the test results analysis under both steady-state and transient settings [14]. Direct power control with predictive phasor measurement for shunt active power filters.…”

Section: Introductionmentioning

confidence: 99%

PSO based optimized PI controller design for hybrid active power filter

Sujith

Govindaraj

Pardeshi

et al. 2023

IJPEDS

View full text Add to dashboard Cite

This research study presents the design and simulation of a hybrid active power filter (HAPF) for reducing harmonics. The reference currents have been determined using the synchronous reference frame technique. To achieve its goals, the proposed HAPF employs AI algorithm known as particle swarm optimization (PSO) to fine-tune the proportional-integral PI controller's parameters. With the help of PI-PSO controller the DC link voltage is regulated in the HAPF-inverter. A non-linear current control strategy based on hysteresis employed here to construct the pulse gate by comparing the retrieved reference and real currents necessitated by the HAPF. Simulations were carried out in MATLAB and shown that the proposed method is extremely adaptable and efficient in reducing harmonic currents caused by non-linear loads.

show abstract

“…Hysteresis controllers have been introduced in the published works and generated a great deal of interest [14] in SP-SAPF applications [15,16]. This type of controllers provides overcurrent protection capability for versatility and simplicity of practical implementation.…”

Section: Introductionmentioning

confidence: 99%

Experimental Evaluation of Single-Phase Shunt Active Power Filter Based on Optimized Synergetic Control Strategy for Power Quality Enhancement

Gherouat¹,

Hassam²,

Aissa³

et al. 2021

JESA

View full text Add to dashboard Cite

In this paper, a synergetic approach based on particle swarm optimization (SC-PSO) technique is proposed for Single-Phase Shunt Active Power Filter (SP-SAPF). Two-loop cascade controller for SP-SAPF has been designed. In the first loop, a PI controller is used to effectively regulate the DC link voltage. In the second one, a synergetic controller is performed in the current compensation control loop. The various adjustable parameters of the studied synergetic controller are tuned by a PSO algorithm. The objective of this adjustment is to get the optimal control parameters for satisfying requirements of power quality and high dynamic responses for SP-SAPF. The effectiveness of the suggested SC-PSO approach has been proved by simulation and experimental tests using MATLAB/Simulink environment and dSPACE 1104 card for several operating conditions. The experimental results demonstrate that the developed SC-PSO approach is very satisfactory and offers a high performance for both transient and steady states.

show abstract

Optimization of Shunt Active Power Filtering with PI Control in a Three-Phase Three-Wire System

Cited by 4 publications

References 15 publications

Optimized D-Q Vector Control of Single-Phase Grid-Connected Inverter for Photovoltaic System

Optimized D-Q Vector Control of Single-Phase Grid-Connected Inverter for Photovoltaic System

PSO based optimized PI controller design for hybrid active power filter

Experimental Evaluation of Single-Phase Shunt Active Power Filter Based on Optimized Synergetic Control Strategy for Power Quality Enhancement

Contact Info

Product

Resources

About