Optimization of Process Parameters of Aluminum Alloy (Al-6082 T-6) Machined on CNC Lathe Machine for Low Surface Roughness

MK, Singh; Chauhan, Dinesh

doi:10.4172/2169-0022.1000202

Cited by 4 publications

(1 citation statement)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…These studies are mainly for tubes with a relatively small thickness and height. Currently, aluminum tubes with a special long shank shape and relatively large thickness are mainly machined from solid workpieces [18,19]. The major disadvantage of cutting methods is the low coefficient of the using material, especially when the part has a variable cross section and diameter [20].…”

Section: Introductionmentioning

confidence: 99%

IMPROVING THE MECHANICAL PROPERTIES OF Al-Cu-Mg-Mn ALLOY TUBES THROUGH PLASTIC DEFORMATION

Le¹,

Dac

Bui

2021

Acta Metall Slovaca

View full text Add to dashboard Cite

The effect of plastic deformation upon the grain structure and mechanical properties of Al-Cu-Mg-Mn alloy tubes under upsetting was investigated. It was found that plastic deformation techniques such as cold upsetting can overcome the disadvantages of the cutting process, such as the anisotropy of the original material, no grain structure, and not high mechanical properties, while also improving the mechanical properties of the product in local plastic deformation zones by changing the grain and fiber structure of the material. This article presents the results of our research and evaluates the increase of material durability in the tubes’ deformation zones compared with the initial state. In this study Al-Cu-Mg-Mn alloy material had been cutting with turn machine and plastic deformation by upsetting. Microstructures and hardness variations of cut surfaces that are obtained with different processes have been investigated.

show abstract

Section: Introductionmentioning

confidence: 99%