Optimization of laser osteotomy at 1064 nm using a graphite topical absorber and a nitrogen assist gas jet

Jivraj, Jamil; Chen, Chaoliang; Barrows, Dexter; Gu, Xiaodong; Yang, Victor X. D.

doi:10.1364/boe.10.003114

Cited by 2 publications

(1 citation statement)

References 32 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The work presented in this chapter resulted in the following journal publication [136]: Jivraj, Jamil, Chaoliang Chen, Dexter Barrows, Xijia Gu, and Victor XD Yang. "Optimization of laser osteotomy at 1064 nm using a graphite topical absorber and a nitrogen assist gas jet."…”

Section: Chaptermentioning

confidence: 99%

Penscriptive Depth-Controlled Robotic Laser Osteotomy

Jivraj¹

2021

Preprint

Self Cite

View full text Add to dashboard Cite

Bone cutting in surgery is currently done using un-intelligent tools that depend on the proficiency of the surgeon to prevent damage to underlying critical structures. As one can imagine, damage isn’t always prevented. Iatrogenic damage to dura and sub-dural neural structures during osteotomical procedures such as a craniotomy can result in increased patient morbidity. This dissertation proposes the development of a robot-guided laser osteotome (bone cutter) with the use of inline optical coherence tomography (OCT) to precisely control the cutting depth in real-time. The all-fiber system design integrates a high peak-power pulsed Yb-doped fiber laser (1064nm) coupled directly into the sample arm of a swept-source OCT system (λc = 1310nm) with a fourth-order power disparity between the OCT system and fiber laser. Sub-millimeter accuracy was achieved in percussion drilling of phantom and porcine bone. Through the use of optical topographic imaging (OTI), this work presents a novel method for the surgeon to identify arbitrary trajectories for desired cuts. A surgical pencil is used to demarcate cutting trajectories for the robot to follow directly onto the boney surface. OTI imaging combined with a novel algorithm developed through this work allows the penscribed line to be isolated and translated into spatial attitude information for the robot to guide the end effector-mounted laser along. Sub-millimeter trajectory following accuracy was achieved. This work also demonstrates the first use of OCT in continuous, real-time refocusing of the optical end-effector in order to maintain cut quality. The focus of the laser was able to be maintained within the Rayleigh length of the focused Gaussian beam for linear feed rates up to 1mm/s at a 45◦ surface incline. Finally, optimization of bone ablation is explored in this dissertation. The use of graphite as a high-absorption topical chromophore and the use of nitrogen as an assist gas in the form of a coaxial jet are both analyzed to determine how to achieve the highest etch rate in bone. The results in this dissertation show that the topical application of graphite was able to significantly reduce the mean and variance of etching performance; an improvement by at least two orders of magnitude in the time to 0.5mm etch depth is demonstrated. It is also demonstrated that etch rate during ablation can be optimized for coaxial nitrogen flow (30SCFH out of a nozzle with 3mm output diameter); higher and lower flow rates showed slower etch rates. It is hypothesized that a system such as the one developed in this dissertation will increase the precision of bone cutting, decrease the amount of time needed to make cuts into sensitive structures and also address certain issues of unsuccessful uptake of lasers in modern medicine.

show abstract

Section: Chaptermentioning

confidence: 99%