Optimization of corona ring design for a 400KV non-ceramic insulator

Murawwi, Esam Al; Mohammed, Alip; Alip, Zapaer; El-Hag, Ayman H.

doi:10.1109/eic.2013.6554269

Cited by 8 publications

(2 citation statements)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The axial points are useful and necessary when the 2 𝑘 design is not efficient on fitting a first-order model, since through them it is possible to incorporate the quadratic terms into the model [31,38]. The adequacy or not of the models can be ascertained through the 𝑅 2 and 𝑅 𝑎𝑑𝑗 2 coefficients, obtained by running an ANOVA test and also the residues normality analysis [11, 30,31,38]. Basically, the region of operability and interest determines the value for the axial distance α, that may vary from 1 to √𝑘.…”

Section: 𝚽 =mentioning

confidence: 99%

A Multiobjective Optimization of the Welding Process in Aluminum Alloy (AA) 6063 T4 Tubes Used in Corona Rings Through Normal Boundary Intersection and Multivariate Techniques

Luz

Romão

Streitenberger

et al. 2021

Preprint

View full text Add to dashboard Cite

The welding process in aluminum is not a simple task to carry out. Problems such as weld bead discontinuity, cracks, and lack of penetration commonly occur in this kind of process. Thus, it is extremely necessary to have an accurate specification of the parameters in order to achieve optimal values for the investigated responses. In view of this, the present paper proposes the application of a multiobjective optimization approach considering multivariate constraints based on the simultaneous confidence intervals and the elliptical region of the correlated data. Structured experiments for the welding process of aluminum alloy (AA) 6063 TA tubes used in corona rings were performed according to a face centered composite design with 4 factors, wire feed rate (Wf), arc voltage (V), contact tip to the workpiece distance (Ct) and motor frequency (Fr), resulting in 31 experiments. Poisson regression was applied to model the values of yield (Y), dilution (D), reinforcement index (RI) and penetration index (PI), allowing to estimate the optimal individual values with regards to the multivariate constraints. Rotated factor scores were obtained in order to replace the original data and therefore the factor multivariate square error was used as objective functions to be minimized through normal boundary intersection method. It was possible to observe that a satisfactory weld bead with large values of PI, D and Y and a small value of RI, was reached as pre specified by the manager of the process.

show abstract

Section: 𝚽 =mentioning

confidence: 99%

A Multiobjective Optimization of the Welding Process in Aluminum Alloy (AA) 6063 T4 Tubes Used in Corona Rings Through Normal Boundary Intersection and Multivariate Techniques

Luz

Romão

Streitenberger

et al. 2021

Preprint

View full text Add to dashboard Cite

show abstract

“…One way to reduce corona discharge is using corona rings [1,2]. Insulators for voltages above 132 kV should be equipped with corona rings as part of insulation system [3].…”

Section: Introductionmentioning

confidence: 99%