Optimization of a High-Frequency Current Transformer Sensor for Partial Discharge Detection Using Finite-Element Analysis

Abstract

Abstract-High Frequency Current Transformer (HFCT) sensors are widely used for Partial Discharge detection due to their versatility, high sensitivity and wide bandwidth. This paper reports on a Finite Element Analysis (FEA) methodology that can be employed to optimize HFCT performance. The FEA model consists of accurate 3D representations of the sensor components. Two different FEA software modules were used in order to cover the wide operating frequency range of the sensor. The simulation computes the frequency response of the sensor in the range 0.3 MHz -50 MHz for various HFCT geometric and material parameters, specifically the number of winding turns, spacer thickness, aperture size and core material. A prototype HFCT was constructed and the measured response compared with that of the simulation. The shapes of the responses were similar, with the simulated sensitivity being higher than the measured sensitivity by 1 dB on average. The measured low frequency cutoff of the sensor was found to be only 0.05 MHz lower than that of the simulation.

Electrical Detection of Creeping Discharges over Insulator Surfaces in Atmospheric Gases under AC Voltage Application

“…A 50 Ω RG-405 coaxial cable connects the plane electrode with a pre-installed high-pressure rated coaxial feedthrough. A coaxial cable connected to the low-pressure side of the feedthrough is then connected to the configuration shown in Figure 5, similar implementations of which were presented in [20,21]. Two SMA connectors are mounted on the top and bottom of a C101 alloy copper rod.…”

Contactless measurement of electric current using magnetic sensors

“…Demagnetization can be achieved by increasing the burden [64]. High-Frequency Current Transformers work up to 50 MHz [65].…”

Assessment of Macro Fiber Composite Sensors for Measurement of Acoustic Partial Discharge Signals in Power Transformers

“…In piezoelectricity, the quantities involved are tensors, despite some particular directions of the crystals, the vectors are in the same direction [24]. The relations of scalar quantities are given by (1) and (1), respectively:…”

“…P OWER Transformers are high-cost equipment and essential for the electrical system operation. During the operation of power transformers, some factors such as overload, nonlinear loads and switching can cause the degradation of the insulating system, which allows the occurrence of internal partial discharges [1]- [3]. Partial discharges (PD) are random phenomena which have a direct influence on the transformers failures as well as on the interruptions in the power system.…”