Optimising Performance of Mature Reservoir: An Innovative Use of Coiled Tubing Drilling Technology to Tap Unswept Reserves, Alwyn North UKCS

Abstract

TX 75083-3836, U.S.A., fax 01-972-952-9435. AbstractThis paper describes the rationale, the planning and the preliminary results of the first Coiled Tubing Drilling (CTD) experience for TotalFina. The objective was to enhance production from a high water-cut oil well producing under unstable conditions and located in an area of possible upsides. This well was drilled in 1990 on the edge of a fault-scarp degradation complex in the Brent East panel of the Alwyn Field. The geological uncertainties in this complex area needed to be reduced and it was necessary to reassess seismic, core and reservoir data to progress the current knowledge base. Analytical calculations supported 3D reservoir modelling techniques to constrain some of the uncertainties.Drilled in 1999, well 3/9a-N30Y was the first coiled tubing sidetrack from a producing well on Alwyn. The motherbore, 3/9a-N30, was still producing around 380 stb/d, although production had recently become intermittent.The well path presented a challenging trajectory due to the location of the unswept area in relation to the direction of the motherbore. After drilling 240m a series of operational issues arose, necessitating the drilling of the world's deepest open hole sidetrack with coiled tubing, but ultimately the BHA was left in hole. The coiled tubing was then utilised as an uncemented liner, perforations using slim guns were added along the liner, and the well was brought onto production. The CTD drain alone produced at an initial rate of 2900 stb/d, which stabilised out at 1200 stb/d after an initial rise in water cut.The successful outcome of 3/9a-N30, which was drilled in a complex offshore environment, confirmed the viability of CTD as a technique for accessing smaller pockets of remaining oil, whilst some of the operational difficulties encountered highlighted the need to simplify future trajectories to maximize the chance of success. With the possibility of drilling future CTD wells, further increases in productivity and reserves will be achieved at a significantly lower cost compared to conventional drilling.