Optimal charging of battery using solar PV in standalone DC system

Anand, Sandeep; Farswan, Rajesh Singh; Mangu, B.; Fernandes, B. G.

doi:10.1049/cp.2012.0339

Cited by 11 publications

(4 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The solar PV is use for charge the backup battery with help of boost converter [3].the solar PV module use in simulation is 1kw Sun power SPR-X20-255with specification in the Table .3.The Solar PV output is boosted and applied for charging process of battery , [4,5] A Li-ion battery of 24V is utilized which will act as backup system to charging station .Simulation result is shown in figure 10 where an charging of battery is observed by increasing of SOC where minimum SOC is kept 50% which is increasing as show in output result of simulation.…”

Section: Simulation Of Solar Pv With Boost Convertermentioning

confidence: 99%

Simulation of Grid Connected EV Charging Station with Renewable Energy Source

Shirsat¹

2019

IJATCSE

View full text Add to dashboard Cite

This paper helps to understand the configuration of grid connected EV charging station which is integrated with Renewable energy system. Which is an Solar PV rooftop system and act as a backup system for meeting power demand of an EV charging station which help to reduce stress on grid. Renewable energy sources is an best solution for production of energy as an local generation of power which help charging station run economically as it collaborate with grid connected charging station at off peak period the power is taken by grid for operation of station and at that time the solar pv system charges the backup batteries which are connect to station for supplying power to charge EV's at peak hours .As well as the backup battery bank which charge whole day with Solar PV system can be used for battery swapping for EV's .MATLAB/SIMULINK is used to simulate the grid connected EV charging station with renewable energy sources which help to obtain results of simulation model .

show abstract

Section: Simulation Of Solar Pv With Boost Convertermentioning

confidence: 99%

Simulation of Grid Connected EV Charging Station with Renewable Energy Source

Shirsat¹

2019

IJATCSE

View full text Add to dashboard Cite

show abstract

“…Jun Pan et al [15] present according to the output characteristics of photovoltaic (PV) array and battery charging characteristics, design of a PV charging system with maximum power point tracking (MPPT). Sandeep Anand et al [16] proposed charged controller for limitation in battery life. They discuss in this paper in standalone dc system, dc-dc converter was used to interconnect solar photovoltaic (PV) and battery.…”

Section: Introductionmentioning

confidence: 99%

A Novel and Efficient INC Based MPPT for PV System

2021

View full text Add to dashboard Cite

This paper discuss the Incremental Conduction based MPPT for tracking the solar power. Due to increment of power demand here to find the new type of generation system. The concept of Renewable Energy Source (RES) is now become a most popular for generation of power. There are basically three types of RES is used for generation process, Wind, PV, fuel cell. Solar system is one of the best RES technique for generation of electrical power but it have some drawback. It is only used in the daytime and has low efficiency. For improving the efficiency of the system here maximum power tracking is needed. Here Incremental Conduction based MPPT for tracking the solar power is used. The whole model is simulated in MATLAB /SIMULINK for checking the performance of the system and is applicable to different type of domestic loads. The THD of the system is calculated.

show abstract

“…In a hybrid system, PV and batteries are connected in parallel to the DC bus and the DC link voltage is determined by the battery voltage. The charging–discharging pattern of the battery is decided by the random fluctuations in PV and load power and hence cannot be controlled [9]. As the life of the battery is affected by the frequency of charging and discharging, temperature, current peaking etc.…”

Section: Introductionmentioning

confidence: 99%

A control strategy to enhance the life time of the battery in a stand‐alone PV system with DC loads

Maheswari

Rao

Sivakumaran

et al. 2017

IET Power Electronics

View full text Add to dashboard Cite

This study proposes a unique control strategy to enhance the life time of the battery in a stand-alone photovoltaic (PV) system employing energy storage devices such as battery and super capacitor. The intermittent fluctuations in PV power and load power affect the DC bus voltage leading to a random and frequent charging/discharging profile of the battery since the controlling converters are operated as constant voltage sources. To overcome this drawback, the supercapacitor converter is commanded as a constant voltage source so as to adapt to varying load conditions and the battery converter is commanded as a constant current source. This strategy helps to decouple the power imbalances from the charge-discharge profile of battery, thereby contributing to the improved battery life. The detailed experimental results are presented. Further, the proposed control strategy is tested and validated under various scenarios.

show abstract

Optimal charging of battery using solar PV in standalone DC system

Cited by 11 publications

References 0 publications

Simulation of Grid Connected EV Charging Station with Renewable Energy Source

Simulation of Grid Connected EV Charging Station with Renewable Energy Source

A Novel and Efficient INC Based MPPT for PV System

A control strategy to enhance the life time of the battery in a stand‐alone PV system with DC loads

Contact Info

Product

Resources

About