On the Performance of Device-to-Device Underlay Communication with Simple Power Control

Yu, Chengpu; Tirkkonen, Olav; Doppler, Klaus; Ribeiro, C.B.

doi:10.1109/vetecs.2009.5073734

Cited by 264 publications

(179 citation statements)

References 9 publications

Supporting

Mentioning

176

Contrasting

Unclassified

Order By: Relevance

“…2D communication has been proposed to increase spectral efficiency of cellular networks by allowing direct communication between two mobile users (called D2D users) without traversing the Base Station (BS) or core network [1]. D2D communication is also considered to be a new technological component for a 3GPP LTE-A system, aiming to reduce energy consumption, improve network utilization, and decrease end-to-end latency of cellular users [2].…”

Section: Introductionmentioning

confidence: 99%

“…In an underlay D2D model, the D2D users can reuse the licensed cellular spectrum and communicate directly with each other (while remaining controlled by the BS). Note that both the cellular and D2D users share the same radio resources, and therefore it is essential to control the interference caused by cellular users to D2D users, and vice versa [1]. Therefore, the problem of interference management is crucial for effective performance of such a network.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

QoS-Oriented Mode, Spectrum, and Power Allocation for D2D Communication Underlaying LTE-A Network

Asheralieva

Miyanaga

2016

IEEE Trans. Veh. Technol.

View full text Add to dashboard Cite

-This paper investigates the problem of resource allocation for Device-to-Device (D2D) Communication in a Third Generation Partnership Project (3GPP) Long Term Evolution Advanced (LTE-A) network. The users in the network can operate either in a traditional cellular mode communicating with each other via the eNB, or in D2D mode communicating with each other without traversing the eNB. In the considered model, the D2D users and cellular users share the same radio resources. Particularly, each resource block (RB) within the available bandwidth can be occupied by one cellular and several D2D users. Hence, the problem of interference management is crucial for effective performance of such a network. The two-fold aim of the proposed algorithm is to i) mitigate the interference between cellular and D2D users and ii) improve the overall user-perceived quality of service (QoS). To control the interference, for each user we define a certain target interference level, and constrain the interference from the other users to stay below this level. The corresponding optimization problem maximizes the QoS of the users by minimizing the size of the buffers of user equipments (UEs). Performance of the algorithm has been evaluated using the OPNET-based simulations. The algorithm shows improved performance in terms of mean packet end-to-end delay and loss for UEs when compared to other relevant schemes.

show abstract

Section: Introductionmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

QoS-Oriented Mode, Spectrum, and Power Allocation for D2D Communication Underlaying LTE-A Network

Asheralieva

Miyanaga

2016

IEEE Trans. Veh. Technol.

View full text Add to dashboard Cite

show abstract

“…Device-to-Device (D2D) [1] communication is one of the latest technology in recent years. Compared with the traditional communication system, D2D communication has great advantages in both spectrum efficiency and coverage.…”

Section: Introductionmentioning

confidence: 99%

Combination Synchronization Protocol with Center Nodes in Device-to-Device Communication System

Fan¹,

Wang²,

Lu³

2016

Proceedings of the 2015 4th International Conference on Sensors, Measurement and Intelligent Materials

View full text Add to dashboard Cite

Abstract:In this paper, we propose a hybrid synchronous algorithm based on the combination of distributed and centralized algorithm. First of all, we put forward the concept of local cluster and generalized local cluster. The cluster is a collection of synchronous UE meeting certain conditions and has a center UE. Through this mechanism, we can finish many synchronous parts in advance what we call pre-synchronization which can reduce system latency. When we need system synchronization, we will use the flooding time synchronous protocol. The algorithm has low latency as well as high accuracy and good robustness.

show abstract

“…These schemes manage the interference from the D2D users to the cellular users and vice versa. The work in [4] and [5] control the interference of the D2D links to the cellular users by limiting the maximum transmit power of the D2D users. Authors in [6] aim at minimizing the maximum interferences from both cellular users to D2D users and from Part of this work has been performed in the framework of the FP7 project ICT-317669 METIS, which is partly funded by the European Union.…”

Section: Introduction and Related Workmentioning

confidence: 99%

“…The existing scenarios in literature have investigated the coexistence of only one D2D user with a cellular user in a single frequency band [4], [5], [9], [10], while by proper power control and efficient mode selection multiple D2D users can communicate in one cell for higher network throughput. Therefore, in our work, we assume that more than one D2D user may reuse the spectrum to improve capacity.…”

Section: Introduction and Related Workmentioning

confidence: 99%

Interference management for multiple device-to-device communications underlaying cellular networks

Shalmashi

Miao

Slimane

2013

2013 IEEE 24th Annual International Symposium on Personal, Indoor, and Mobile Radio Communications (PIMRC)

View full text Add to dashboard Cite

Interference management for multiple device-to-device communications underlaying cellular networks. In: 2013 IEEE 24th International Symposium on Personal Indoor and Mobile RadioCommunications (PIMRC) (pp. 223-227 SERVEH SHALMASHI, GUOWANG MIAO, SLIMANE BEN SLIMANEThis is an author produced version of the paper.Access to the published version may require subscription.Published with permission from: IEEE Abstract-We study the problem of interference management for device-to-device (D2D) communications where multiple D2D users may coexist with one cellular user. The problem is to optimize the transmit power levels of D2D users to maximize the cell throughput while preserving the signal-to-noise-plusinterference ratio (SINR) performance for the cellular user. This is the so-called multi rate power control problem. We investigate the problem under two assumptions, the availability of the instantaneous or average channel state information (CSI) at the base station. In the first case, D2D transmit power levels adapt to fast fading, whereas in the second case, they only adapt to slow fading. In the latter assumption, the cellular user has a maximum outage probability requirement. With numerical results, we study the trade-off between the signaling overhead, that is frequent CSI feedbacks, and the overall system performance, that is the maximum achievable cell capacity, for D2D communications underlying cellular networks.

show abstract

On the Performance of Device-to-Device Underlay Communication with Simple Power Control

Cited by 264 publications

References 9 publications

QoS-Oriented Mode, Spectrum, and Power Allocation for D2D Communication Underlaying LTE-A Network

QoS-Oriented Mode, Spectrum, and Power Allocation for D2D Communication Underlaying LTE-A Network

Combination Synchronization Protocol with Center Nodes in Device-to-Device Communication System

Interference management for multiple device-to-device communications underlaying cellular networks

Contact Info

Product

Resources

About