Nutrient Content in Buckwheat Milling Fractions

A top fermented beer was brewed from 100% buckwheat malt and sensory and analytical characterisation was carried out. Difficulties with lautering and filtration were encountered during the brewing process, which resulted in problems during fermentation and beer filtration. The beer was evaluated in the fresh and forced aged state for the following attributes: odour, purity of taste, mouthfeel, tingling, and bitterness. Analytical results indicated that the buckwheat beer compared quite closely to a typical wheat beer with regard to pH, FAN, fermentability and total alcohol. However, the extract of the buckwheat wort was lower, resulting in a final extract yield of 54.5%. GC analysis of the resultant beer revealed commonly encountered levels of the esters that give beer a fruity character. A low level of fusel alcohols, in comparison to a typical wheat beer, was detected. A high level of ethyl caprinate (coconut flavour) and lauric acid (fatty odour) was detected. Sensory analysis indicated that the buckwheat beer was acceptable with regard to odour, purity of taste, mouthfeel, tingling and bitterness. In conclusion, results of this study prove buckwheat's qualification as a gluten-free brewing material and with process optimisation, its readiness for marketing.

Section: Introductionmentioning

confidence: 99%

Processing of a Top Fermented Beer Brewed from 100% Buckwheat Malt with Sensory and Analytical Characterisation

Phiarais

Mauch

Schehl

et al. 2010

“…In recent years, buckwheat has regained importance as an alternative crop for organic cultivation and as an ingredient for health food products 36 . Fagopyrum esculentum Moench (common buckwheat) is the most economically efficient grown buckwheat species 20 .…”

Section: Introductionmentioning

confidence: 99%

Optimisation of a Mashing Program for 100% Malted Buckwheat

Wijngaard

Arendt

2006

The objective of this study was to develop a temperature programmed mashing profile for 100% buckwheat malt. Both standard brewing methods and a rheological tool (Rapid Visco Analyser) were used to characterise worts and mashes. An optimal grist : liquor ratio of 1: 4 was observed. At this ratio, buckwheat malt showed a gelatinisation temperature of 67°C and barley malt 62°C. A one hour stand at 65°C exhibited higher FAN levels, fermentable extracts and lower viscosity values than stands at 67°C or 69°C, and was therefore used in further mashing trials. An extra mashing step of 30 min, at any of the tested temperatures, increased extract values a minimum of 4%, decreased viscosities a minimum of 0.20 mPas, and increased fermentable extracts 12%. Best results were obtained when a mashing-in temperature was used in the range of 35°C to 45°C. These mashing-in temperatures were used to design an optimal mashing procedure: 15 min at 35°C; 15 min at 45°C; 40 min at 65°C; 30 min at 72°C; 10 min at 78°C. This program showed higher extract values and fermentable extract values (72.7% and 49.9%) than obtained by congress mashing (65.3% and 40.0%), thus successfully optimising the mashing program.

“…There is a renewed interest in buckwheat as an alternative crop for organic cultivation as well as an ingredient for health food products 22 . Widely grown in Asia, Central and Eastern Europe, Fagopyrum esculentum Moench (common buckwheat) is traditionally used for pasta, blended bread and other types of flour 11 .…”

Section: Introductionmentioning

confidence: 99%

Use of Response Surface Methodology to Investigate the Effectiveness of Commercial Enzymes on Buckwheat Malt for Brewing Purposes

Phiarais

Schehl

Oliveira

et al. 2006

The influence of two factors, total concentration and fraction of three pairs of commercial enzymes, which showed statistical significance (Biocellulase W with Hitempase 2XL, Biocellulase W with Amylo 300 and Amylo 300 with Hitempase 2XL), were studied for their overall effect on buckwheat wort quality using response surface methodology (RSM). This study revealed that the addition of increasing levels of Hitempase 2XL to the buckwheat mash increased colour, extract levels, wort filtration, fermentability and total fermentable extract (TFE), along with decreasing viscosity values. Results also determined a high level of fermentability when an enzyme combination of 30% Biocellulase and 70% Hitempase was added to the mash. The addition of increasing levels of Amylo 300 to buckwheat mashes resulted in increases in fermentability and total fermentable extract (TFE), along with increases in total soluble nitrogen (TSN), free amino nitrogen (FAN) and Kolbach index (KI). With regard to the proposed optimal regime, although no synergistic effect was found when the three enzymes were used together, the optimum conditions for the production of buckwheat wort with lowest viscosity, highest extract and optimal fermentability were achieved using a joint model. Overall, the findings of this study demonstrate the feasibility of producing wort suitable for the brewing of glutenfree beer from 100% malted buckwheat with careful optimisation of enzyme types and dosage levels.