Numerical Study the Effect of Gap Ratio on Flow Characteristics and Heat Transfer in Staggered Tube Banks

Abstract

Condenser is a type of heat exchanger that serves as condensation for turbine output steam. In general, a steam power plant uses a surface condenser. This type of condenser is a type of shell and tube. Condensers have a phenomenon of convection heat transfer. The change in distance between condenser tubes is one way to increase the rate of heat transfer. To produce maximum heat transfer, it can be determined by the variety of distances between tubes. The research was conducted by analyzing the flow characteristic and heat transfer around condenser tube banks with gap ratio variation (s/d), which compares transverse distance (ST ) and tube diameter (d) with variations of 3.2, 2.7, 2, and 1.7. 2-dimensional simulation with Computational Fluid Dynamics (CFD) is a numerical method and algorithm for solving and analyzing problems that occur in fluid flows. Based on the results obtained, the smaller the Gap Ratio, the lower the outlet temperature produced and the maximum heat transfer, but the pressure drop value obtained the bigger. Also, the smaller Gap ratio, the bigger v max produced. The lowest outlet temperature value at the variation of 1.7 is 310.66 K, and the coefficient of heat transfer is 103.34 W/m2K. Pressure drop produced at variation 1.7 is 515.99 Pa. Variation 2 is the best gap ratio variation, seen from the heat transfer result and the pressure drop value is not too large. The coefficient heat transfer and pressure drop in variation 2 are 76.95 W/m2K and 119.17 Pa.

The Advantages and Challenges of Carbon Fiber Reinforced Polymers for Tidal Current Turbine Systems - An Overview

“…It is the most predictable [7][8][9], has reached the early stages of technological maturity [8,10], and is a promising source of energy [11][12][13][14][15]. Even without abandoning research on conventional energy sources [16][17][18], research on ocean renewable energy is important. Tidal current energy is produced using a similar process to how wind energy is produced, except it is entirely immersed underwater.…”

Risk Management in the LPG Refrigerated Green Terminal Project for Sustainable Development Goals

“…This standard aims to guide industries to manage different types of risk from different industries with different organizational sizes, types, complexity, structures, activities, and locations [3]. This standard can be implemented in several fields, such as in power plants [4][5][6][7][8][9][10]. Research on the oil and gas sector still needs to be developed even though the ocean renewable energy sector is being researched a lot [11][12][13][14][15].…”

A study of the temperature distribution in the OTEC cold water pipe using a heat and mass transfer approach

“…Figure 1 illustrates the Rankine Cycle used in Ocean Thermal Energy Conversion (OTEC). In this cycle, cold water from the deep sea is directed towards the heat exchanger [15,16], specifically the condenser [17], where it facilitates the transition of the working fluid from a two-phase state to a saturated liquid form. On the other hand, warm water originating from surface sea streams is directed towards a heat exchanger, specifically an evaporator.…”