Numerical Study on the Effect of Low‐Frequency Power Supply on Desulfurization in the Electroslag Remelting Process

Abstract

In the electroslag remelting (ESR) process, low‐frequency power supply can significantly reduce power consumption and achieve three‐phase balance of power supply. Therefore, a transient coupling model of fluid flow, heat transfer, and component transport in the ESR process, which is coupled to the electromagnetic field calculated using Maxwell 3D software, is established to study the influence of low‐frequency power supply on desulfurization. When a 50 Hz power supply is used, a skin effect is observed in the metal, and the direction of the Lorentz force at the slag/metal interface changes. However, this effect becomes less pronounced with decreasing current frequency. Sulfur is mainly transferred at the electrode tip, and the desulfurization rate is approximately 50%. Electrochemical reactions mainly occur at the electrode tip/slag interface and the metal pool/slag interface. The removal rate of sulfur using direct current (DC) power supply is less than that using an alternating current power supply. The DC reverse polarity power supply leads to higher desulfurization rate than DC straight polarity, which is 74% and 31%, respectively. The sulfur removal rate increases from 81.37% to 84.59% as the frequency decreases from 50 to 2 Hz because of the longer electrochemical reaction time at this lower frequency.

Numerical Simulation of Electromagnetic Field in Slab Electroslag Remelting Process with Double Electrode Series

“…The interaction of the electromagnetic field provides the heat required for electrode melting in the electroslag remelting process and has an important influence on the temperature change and the solidification structure of the final ingot. Therefore, it is very important to study the changes in the electromagnetic field and temperature field in the process of electroslag remelting, optimize the process of electroslag remelting and obtain high-quality ingot [12][13][14][15][16][17][18][19][20][21][22][23].…”