Numerical Investigation of the Performance Impact of Stator Tilting Endwall Designs on a Mixed Flow Turbine

Abstract

This paper numerically investigates stator endwall designs for a mixed flow turbine. One key design parameter studied is the tilting angle of the stator endwall. By examining stator designs with different tilting angles, the aim of this paper is to improve the efficiency of the studied mixed flow turbine at low velocity ratio working conditions. The performance curve at the design speed was chosen for the comparison between the baseline design and the tilted endwall designs. First, the numerical predictions for the baseline design were validated with experimental data. Then, to understand the mechanism of the performance variation between the different designs, the internal flow field was analyzed in detail. It was found that the tilting stator endwall could form a geometric “kink” in the endwall profiles. On the shroud side, certain designs with such kink caused local flow separations upstream the rotor leading edge. This separation could have the effect of reducing the intensity of the tip leakage vortex and the exit kinetic energy losses at the rotor outlet and may also improve the performance of the exhaust diffuser. As a result, the peak of the efficiency curve shifted toward lower velocity ratio. If the turbine stage incorporated a downstream exhaust diffuser, the optimal design in this study showed a shift of the velocity ratio of the peak efficiency point from 0.62 to 0.60 compared with the baseline. The maximum efficiency improvement was 1.3% points, which occurred at low velocity ratio. Meanwhile, the peak efficiency was 0.2% points higher than the baseline. If the exhaust diffuser was removed, a similar shift of the efficiency curve was observed but less efficiency gain was achieved at the low velocity ratio condition. A preliminary unsteady simulation was also conducted for the optimal design in this study.

The Effect of Blade Angle Deviation on Mixed Inflow Turbine Performances

“…The design and the experimental data obtained by Rajoo [14] are used for validation throughout the current research. Gao Y. et al [15] investigated stator end wall designs numerically for a mixed flow turbine. Lee et al [16] designed and analyzed the volute of a radial and a mixed flow turbine.…”