Numerical Investigation of Injection-Induced Fracture Propagation in Brittle Rocks with Two Injection Wells by a Modified Fluid-Mechanical Coupling Model

Abstract

Hydraulic fracturing is a key technical means for stimulating tight and low permeability reservoirs to improve the production, which is widely employed in the development of unconventional energy resources, including shale gas, shale oil, gas hydrate, and dry hot rock. Although significant progress has been made in the simulation of fracturing a single well using two-dimensional Particle Flow Code (PFC2D), the understanding of the multi-well hydraulic fracturing characteristics is still limited. Exploring the mechanisms of fluid-driven fracture initiation, propagation and interaction under multi-well fracturing conditions is of great theoretical significance for creating complex fracture networks in the reservoir. In this study, a series of two-well fracturing simulations by a modified fluid-mechanical coupling algorithm were conducted to systematically investigate the effects of injection sequence and well spacing on breakdown pressure, fracture propagation and stress shadow. The results show that both injection sequence and well spacing make little difference on breakdown pressure but have huge impacts on fracture propagation pressure. Especially under hydrostatic pressure conditions, simultaneous injection and small well spacing increase the pore pressure between two injection wells and reduce the effective stress of rock to achieve lower fracture propagation pressure. The injection sequence can change the propagation direction of hydraulic fractures. When the in-situ stress is hydrostatic pressure, simultaneous injection compels the fractures to deflect and tend to propagate horizontally, which promotes the formation of complex fracture networks between two injection wells. When the maximum in-situ stress is in the horizontal direction, asynchronous injection is more conducive to the parallel propagation of multiple hydraulic fractures. Nevertheless, excessively small or large well spacing reduces the number of fracture branches in fracture networks. In addition, the stress shadow effect is found to be sensitive to both injection sequence and well spacing.

RETRACTED ARTICLE: Analysis of sponge city water pollution characteristics and urban music emotional expression based on GIS system

“…In comparison, some audiences put more attention and energy into the more popular urban music in other cities (Wang et al 2020a). In view of the above-mentioned situation, the audience said that the poor songwriting of the city's music, the small number of singing singers, the narrow communication channels, and the low popularity of songs are all reasons for this phenomenon, and the proportions of the various factors are relatively balanced (Wang et al 2020b).…”

Research and Applications of New Fracturing Technology in Low-Abundance and Greater-Depth Well LN-1 Reservoirs

“…Since the 1970s, a series of studies have been carried out at home and abroad for low-porosity, low-permeability, low-pressure, and low-abundance oil reservoirs, and so far, it has been integrated into a variety of technical directions, including carbon dioxide and natural gas injection (used to increase reservoir pressure and facilitate crude oil flow) [1,2], microbial-enhanced oil recovery (employed to improve reservoir conditions and increase abundance) [3][4][5], as well as horizontal well drilling and multi-well development (utilized to expand contact area) [6,7]. Compared with the above stimulation technology, fracturing technology has the advantages of simple construction, strong effectiveness, prominent pertinence, and good controllability.…”

Investigating the Influence of Joint Angles on Rock Mechanical Behavior of Rock Mass Using Two-Dimensional and Three-Dimensional Numerical Models

“…One of the popularly used discontinuum methods is the discrete element method (DEM), which is commonly adopted to simulate the microcrack initiation, propagation, and coalescence associated with the rock failure processes [7,10]. In addition, a widely used example of the DEM approach is the particle flow code (PFC), based on the bonded particle model (BPM); in this case, the bond is simply broken when the interaction force between two particles overcomes its tensile or shear strength, and the microcrack is produced automatically without further assumptions about where and how the cracks may appear [11].…”