2004
DOI: 10.1088/0953-2048/17/3/026
|View full text |Cite
|
Sign up to set email alerts
|

Normal conducting transfer coil for SQUID NDE

Abstract: We have investigated the performance of a normal conducting transfer coil (n-coil) for nondestructive evaluation with a SQUID. The transfer efficiency, which depends on frequency and wire impedance, has been calculated for several coil designs to determine the performance of the n-coil. We have fabricated a 30 mm diameter n-coil and examined its performance with a high-TC SQUID. If both the pick-up coil and the input coil have 50 turns, then at high frequencies the magnetic field produced by the input coil be… Show more

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
3
1
1

Citation Types

0
14
0

Year Published

2005
2005
2018
2018

Publication Types

Select...
8
1

Relationship

0
9

Authors

Journals

citations
Cited by 16 publications
(14 citation statements)
references
References 9 publications
0
14
0
Order By: Relevance
“…Hence, the weak magnetic flux was transferred from the pickup coils to the input coil surrounding the magnetically sensitive superconducting quantum interference device sensor (JSQ GmbH, Germany). The designs of the pickup coil, capacity, and connected input coil followed a typical conducting transfer coil 23 and the inductance-capacity resonance circuit at a resonant frequency of 5 MHz. The sensitivity of approximately 87 pT was primarily limited by the bandwidth of a radio frequency superconducting quantum interference device controller.…”
Section: Methodsmentioning
confidence: 99%
“…Hence, the weak magnetic flux was transferred from the pickup coils to the input coil surrounding the magnetically sensitive superconducting quantum interference device sensor (JSQ GmbH, Germany). The designs of the pickup coil, capacity, and connected input coil followed a typical conducting transfer coil 23 and the inductance-capacity resonance circuit at a resonant frequency of 5 MHz. The sensitivity of approximately 87 pT was primarily limited by the bandwidth of a radio frequency superconducting quantum interference device controller.…”
Section: Methodsmentioning
confidence: 99%
“…The SQUID sensor unit was composed of a high critical-temperature T c SQUID magnetometer (JSQ GmbH, Germany) in a dewar with a liquid nitrogen refrigerant and a set of shielding cans. Based on a typical conducting transfer coil [ 27 ] (as depicted in Figure 1 ), the weak magnetic flux was transferred from the pickup coils near the sample in an unshielded environment to the input coil surrounding the SQUID sensor, where it was amplified approximately 29-fold. The sensitivity of the entire dual-imaging model SSB was approximately 3 pT/√Hz.…”
Section: Methodsmentioning
confidence: 99%
“…The sensitivity of the entire dual-imaging model SSB was approximately 3 pT/√Hz. The white noise of the system is limited by the thermal noise of the normal-conducting flux transformer [ 27 ]. The environmental noise originated primarily from the concentric excitation coil and slightly from the CCD and cooling fan attached to the scanning probe unit.…”
Section: Methodsmentioning
confidence: 99%
“…A normal conducting transfer coil [15] was used to transfer the weak magnetic flux from the pickup coils close to the sample in an unshielded environment to the input coil surrounding the SQUID sensor. The weak magnetic flux was then amplified by approximately 15 times.…”
Section: System Descriptionmentioning
confidence: 99%